Study tips 100-101

Which two commands will display the current IP address and basic Layer 1 and 2 status of an interface?

What command will allow the administrator to check the changes that have been made prior to saving the new configuration?

which commands will verify the operational status of router interfaces?

Which router command will configure an interface with the IP address 10.10.80.1/19?

which router prompt will be displayed?

Which default gateway address should be assigned to HostA?

What will the router do with this packet?

What is the default administrative distance of the OSPF routing protocol?

which of the following commands could be used in R2?

what type of messaging, if any,occurs between R3 and R4?