Study tips 200-120

Which two locations can be configured as a source for the IOS image in the boot system command?

what router ID will OSPF use for this router?

What commands must be configured on the 2950 switch and the router to allow communication between host 1 and host 2?

Which two statements describe the process identifier that is used in the command to configure OSPF on a router?

what two reasons has the router loaded its IOS image from the location that is shown?

Which three elements must be used when you configure a router interface for VLAN trunking?

Which commands are required to properly configure a router to run OSPF and to add network 192.168.16.0/24 to OSPF area 0?

What will the router consider the most reliable information about the path to that network?

What is the default maximum number of equal-cost paths that can be placed into the routing table of a Cisco OSPF router?

Which command shows your active Telnet connections?