Study tips 642-437

Which command should you use to configure a dial peer to support T.38 fax relay and to use Cisco fax relay if T.38 negotiation is unsuccessful?

which configuration mode is this command entered?

Which two commands should you use on a common gateway between the two IP telephony networks to enable SIP to H.323 interworking?

Which debug command can be used to show events specific to the Cisco Unified Border Element gateway?

Which type of delay describes the amount of time it takes to place a frame onto a physical medium?

Which command will correctly map Class of Service mappings 0 through 7 to Differentiated Services Code Point 0, 10, 18, 26, 34, 46, 48, and 56, accordingly?

Which queuing method is the basis for the low latency queuing?

which speed link should you enable the link fragmentation and interleaving feature?

Which command is used to enable the AutoQoS feature on an incoming interface while also trusting existing quality of service markings?

Which command is used to assign 20% of the bandwidth of an interface to a traffic class with priority?