HOTSPOT
You have a server named LON-SVR1 that runs Windows Server 2012 R2. LON-SVR1 has the Remote Access
server role installed. LON-SVRl is located in the perimeter network.
The IPv4 routing table on LON-SVR1 is configured as shown in the following exhibit. (Click the Exhibit button.)
Your company purchases an additional router named Router1. Router1 has an interface that connects to the
perimeter network and an interface that connects to the Internet. The IP address of the interface that connects
to the perimeter network is 172.16.0.2.
You need to ensure that LON-SVR1 will route traffic to the Internet by using Router1 if the current default
gateway is unavailable.
How should you configure the static route on LON-SVR1? To answer, select the appropriate static route in the
answer area.
Hot Area:
Answer: 
Explanation:
Metric: Specifies an integer cost metric (ranging from 1 to 9999) for the route, which is used when choosing
among multiple routes in the routing table that most closely match the destination address of a packet being
forwarded. The route with the lowest metric is chosen. The metric can reflect the number of hops, the speed of
the path, path reliability, path throughput, or administrative properties.
A metric is a value that is assigned to an IP route for a particular network interface that identifies the cost that isassociated with using that route.
The metric that is assigned to specific default gateways can be configured independently for each gateway.
This setup enables a further level of control over the metric that is used for the local routes.