Hotspot Question
You run Get-ISCSIServerTarget and you receive the following output.
Use the drop-down menus to select the answer choice that completes each statement.
Answer: 
Use the drop-down menus to select the answer choice that completes each statement.
Hotspot Question
You run Get-ISCSIServerTarget and you receive the following output.
Use the drop-down menus to select the answer choice that completes each statement.
select server3.adatum.com
configure the InitiatorIds
http://blogs.technet.com/b/canitpro/archive/2013/01/07/iscsi_2d00_storage_2d00_in_2d00_windows_2d00_server_2d00_20122.aspx
Fifth image on your link confirms that you must use target’s IQN on the initiator.
Did you even read the sentence over the 5th screenshot?
“In the Target box (in the Targets tab) enter the IP address of your Target Server, and click Quick Connect…”
Once you enter in the IP/DNS name of the server, it will show the available iSCSI initiators.
Reckon you’re right there Johnny. IP or fqdn to connect.
question say target to discover not discovered targets, its the FQDN we should add to the target to discover then chose the IQN from the discovered list!
mohamed is right
On the iSCSI Initiator Properties, select the Targets tab, on Quick Connect on the Target’s field, introduce the FQDN of the Target server, which in this case the answer is server3.adatum.com. If the question mentioned “Discovered targets” then the answer qould be the “IQN”.
The second part of the question, when configuring the targets properties you’ll be asked to configure Initiators ID’s, which makes that the correct answer.
http://www.windowsnetworking.com/articles-tutorials/windows-server-2012/configuring-iscsi-storage-part3.html