Which Diskpart command should you run ?

Note: This question is part of a series of question that use the same set of answer choices. Each answer choice may be used once, more than once, or not at all.

Your network contains a server named Server1 that runs windows Server 2008 R2 Service Pack 1 (SP1).

You have a new server that contains a dynamic disk.

You plan to install Windows Server 2008 R2 Service Pack 1 (SP1) on the server.

You attemp to select the dynamic disk during the installation and you receive the following error message. “windows cannot be installed to this hard disk space. The partition contains one or more dynamic volumes that are not supported for installation.”

You need to install Windows Server 2008 R2 SP1 on the disk.

Which Diskpart command should you run ?

A.
automount

B.
extend

C.
format

D.
assign

E.
recover

F.
repair

G.
detach vdisk

H.
merge vdisk

I.
attributes

J.
GPT
K.
offline
L.
expand vdisk
M.
add
N.
break
O.
filesystems
P.
create
Q.
retain
R.
active
S.
remove
T.
list
U.
compact disk
V.
online
W.
rescan
X.
attach vdisk

Explanation:
Prepares an existing dynamic simple volume to be used as a boot or system volume.
Remarks

On a master boot record (MBR) dynamic disk, this command creates a partition entry in the master boot record.
On a GUID partition table (GPT) dynamic disk, this command creates a partition entry in the GUID partition table.

Source: http://technet.microsoft.com/en-us/library/cc755127(v=ws.10).aspx