You have four Remote Desktop Session Host Servers that run Windows Server 2008 R2. The Remote
Desktop Session Host Servers are named Server1, Server2, Server3, and Server4.
You install the Remote Desktop Connection Broker role service on Server1.
You need to configure load balancing for the four Remote Desktop Session Host Servers. You must
ensure that Server2 is the preferred server for Remote Desktop Services sessions.
Which tool should you use?
A.
Group Policy Management
B.
Remote Desktop Session Host Configuration
C.
Remote Desktop Connection Manager
D.
RD Gateway Manager
Explanation:
You can configure a Remote Desktop Session Host (RD Session Host) server to join a farm in RD
Connection
Broker, and to participate in RD Connection Broker Load Balancing, by using the Remote
Desktop Session Host Configuration tool.
To configure RD Connection Broker settings
1. On the RD Session Host server, open Remote Desktop Session Host Configuration. To open
Remote Desktop Session Host Configuration, click Start, point to Administrative Tools, point to
Remote Desktop Services, and then click Remote Desktop Session Host Configuration .
2. In the Edit settings area, under RD Connection Broker, double-click Member of farm in
RD Connection Broker.
3. On the RD Connection Broker tab of the Properties dialog box, click Change Settings.
4. In the RD Connection Broker Settings dialog box, click Farm member.
5. In the RD Connection Broker server name box, type the name of the RD Connection
Broker server.
6. In the Farm name box, type the name of the farm that you want to join in RD Connection
Broker.
7. Click OK to close the RD Connection Broker Settings dialog box.
8. To participate in RD Connection Broker Load Balancing, select the Participate in
Connection Broker Load-Balancing check box.9. Optionally, in the Relative weight of this server in the farm box, modify the server weight. By
default, the value is 100. The server weight is relative. Therefore, if you assign one server a value of
50, and one a value of 100, the server with a weight of 50 will receive half the number of sessions.
10. Verify that you want to use IP address redirection. By default, the Use IP address redirection
setting is enabled. If you want to use token redirection mode, select Use token redirection. For more
information, see About IP Address and Token Redirection.
11. In the Select IP addresses to be used for reconnection box, select the check box next to each IP
address that you want to use.
12. When you are finished, click OK.
Source: http://technet.microsoft.com/en-us/library/cc771383.aspx