The OSPF process must be configured to allow interfaces in specific subnets to participate in the routing process

CORRECT TEXT
There are three locations in a school district of a large city: ROUTER -M, ROUTER -W and
ROUTER -U. The network connection between two of these locations has already functioned.
Configure the ROUTER -M router IP addresses on the E0 and S0 interfaces so that the E0
receives the first usable subnet while the S0 receives the second usable subnet from the network
192.168.160.0/28. Both interfaces would receive the last available ip address on the proper
subnet.

NotE. The OSPF process must be configured to allow interfaces in specific subnets to
participate in the routing process.

CORRECT TEXT
There are three locations in a school district of a large city: ROUTER -M, ROUTER -W and
ROUTER -U. The network connection between two of these locations has already functioned.
Configure the ROUTER -M router IP addresses on the E0 and S0 interfaces so that the E0
receives the first usable subnet while the S0 receives the second usable subnet from the network
192.168.160.0/28. Both interfaces would receive the last available ip address on the proper
subnet.

NotE. The OSPF process must be configured to allow interfaces in specific subnets to
participate in the routing process.

Answer: See the explanation

Explanation:

ROUTER-M> enable
PassworD. Cisco
ROUTER-M# config t
ROUTER-M(config)# interface e0
ROUTER-M(config-if)# ip address 192.168.160.14 255.255.255.240
ROUTER-M(config-if)# no shutdown
ROUTER -M(config-if)# exit
ROUTER -M(config)# interface s0
ROUTER-M(config-if)# ip address 192.168.160.30 255.255.255.240
ROUTER-M(config-if)# no shutdown
ROUTER-M(config-if)# end
ROUTER-M# copy run start



Leave a Reply 1

Your email address will not be published. Required fields are marked *


blatt

blatt

to add a route:
config t
ip route ipaddress subnetmask destination