Which two commands will display the current IP address and basic Layer 1 and 2 status of an
interface? (Choose two.)
A.
router#show version
B.
router#show ip interface
C.
router#show protocols
D.
router#show controllers
E.
router#show running-config
Explanation:
Router#show protocols displays status of configured Layer 2 and 3 protocols while
show controllers Displays statistics for interface hardware including the current IP address
The answers are wrong. It should be B & C. Show controllers don’t show the IP address nor basic layer 1 or layer 2 status…
The reason why B is not a correct answer is that the question asks for both layer 2 & 3 information. ‘show ip interface’ only shows layer 3 information
Cisco kid was clearly high when he cummented…#420blazin
Actually read it again – asking for layer 1&2 not 2&3..
boi your neck look like a layer 2 like shit
U r al Encompetit and delusional
100% agree shoud be B & C ….
It should be B and C, i already checked the command “show controllers” and I didnt see the Ip.
Wrote Cisco 100-101 exam last week, scored 985/1000! Around 8-10 new questions on NTP, Dynamic NAT, IPv6 and so on. SIMs: OSPF, Security, Configuration. I used the NEWEST 100-101 dumps from — http://www.passleader.com/100-101.html (238q, 100% valid!)
You should make it interactive and give us a chance to attempt to answer and then your answer with detailed explanation.