Which Cisco Internetwork Operating System (IOS) command…

Which Cisco Internetwork Operating System (IOS) command is used to define an access list by name?

A.
ip access-list

B.
ip access list

C.
ip access-group

D.
access-list

Explanation:
The ip access-list command is used to define an access list by name. This command is issued in the global configuration mode. The correct syntax of the command
is as follows:
Router(config)# ip access-list {standard | extended} access-list-name
The parameters of the command are as follows:
– standard: Specifies an standard IP access list.
– extended: Specifies an extended IP access list.
– access-list-name: Specifies the name of the access list.
The ip access list command is incorrect because this command does not exist in Cisco IOS terminology. The correct command syntax is ip access-list.
The ip access-group command is incorrect because this command is used to apply an access list to an interface.
The access-list command is incorrect because this command is used to create a numbered access control list entry.
Objective:
Infrastructure Services
Sub-Objective:
Configure, verify, and troubleshoot IPv4 standard numbered and named access list for routed interfaces

https://www.cisco.com/c/en/us/support/index.html