What does the frame-relay interface-dlci command configure?
A.
local DLCI on the subinterface
B.
remote DLCI on the main interface
C.
remote DCLI on the subinterface
D.
local DLCI on the main interface
Explanation:
Frame Relay for ICND Exam http://www.ciscopress.com/articles/article.asp?p=100603&seqNum=3
To assign a data-link connection identifier (DLCI) to a specified Frame Relay subinterface on the
router or access server, or to assign a specific permanent virtual circuit (PVC) to a DLCI, or to apply a
virtual template configuration for a PPP session, use the frame-relay interface-dlci interface
configuration command Example 4-23 Example of frame-relay interface-dlci Command and the
Output of show frame-relay mapR4(config)#interface s1/2.403 point-to-point R4(config-subif)#frame-relay interface-dlci ? <16-1007>
Define a switched or locally terminated DLCI R4(config-subif)#frame-relay interface-dlci 403 ? cisco
Use CISCO Encapsulation ietf Use RFC1490/RFC2427 Encapsulation
ppp Use RFC1973 Encapsulation to support PPP over FR protocol Optional protocol information for
remote end
<cr> R4#show frame-relay map Serial1/2.403 (up): point-to-point dlci, dlci 403(0xC9,0x3090),
broadcast status defined, active R4#