Which command would you use on a Cisco router to verify the Layer 3 path to a host?
A.
tracert address
B.
traceroute address
C.
telnet address
D.
ssh address
Which command would you use on a Cisco router to verify the Layer 3 path to a host?
Which command would you use on a Cisco router to verify the Layer 3 path to a host?
To check the connectivity between a host and a destination (through some networks) we can use both “tracert” and “ping” commands. But the difference between these 2 commands is the “tracert” command can display a list of near-side router interfaces in the path between the source and the destination. The “traceroute” command has the same function of the “tracert” command but it is used on Cisco routers only, not on a PC