The network administrator cannot connect to Switch1 over a Telnet session, although the hosts
attached to Switch1 can ping the interface Fa0/0 of the router. Given the information in the graphic
and assuming that the router and Switch2 are configured properly, which of the following
commands should be issued on Switch1 to correct this problem?
A.
Switch1(config)# line con0
Switch1(config-line)# password cisco
Switch1(config-line)#login
B.
Switch1(config)# interface fa0/1
Switch1(config-if)# ip address 192.168.24.3 255.255.255.0
C.
Switch1(config)# ip default-gateway 192.168.24.1
D.
Switch1(config)# interface fa0/1
Switch1(config-if)# duplex full
Switch1(config-if)# speed 100
E.
Switch1(config)# interface fa0/1
Switch1(config-if)# switchport mode trunk
To route traffic to other vlans, we need to enter the IP address of the next-hop router interface that is directly connected to the switch where a default gateway is being configured. The default gateway receives IP packets with unresolved destination IP addresses from the switch. Once the default gateway is configured, the switch
will have connectivity to the remote networks with which a host needs to communicate.
…in the graphic
i don’t know even where is the graphic that the question talk about …
but it is rational to imagine it and the answer will be right but we have to see the topology
and what this topology look like if you want at least to work as Cisco associate !!!
Since we know hosts can reach the router through the switch, we know that connectivity, duplex.
Speed, etc. are good. However, for the switch itself to reach networks outside the local one, the ip
default-gateway command must be used.