A network administrator needs to configure a serial link between the main office and a remote
location. The router at the remote office is a non-Cisco router. How should the network
administrator configure the serial interface of the main office router to make the connection?
A.
Main(config)# interface serial 0/0
Main(config-if)# ip address 172.16.1.1 255.255.255.252
Main(config-if)# no shut
B.
Main(config)# interface serial 0/0
Main(config-if)# ip address 172.16.1.1 255.255.255.252
Main(config-if)# encapsulation ppp
Main(config-if)# no shut
C.
Main(config)# interface serial 0/0
Main(config-if)# ip address 172.16.1.1 255.255.255.252
Main(config-if)# encapsulation frame-relay
Main(config-if)# authentication chap
Main(config-if)# no shut
D.
Main(config)# interface serial 0/0
Main(config-if)#ip address 172.16.1.1 255.255.255.252
Main(config-if)#encapsulation ietf
Main(config-if)# no shut
can anyone explain the answer B?
EXplanation:
A. There is no Frame Relay here. Then false.
C. The “Encapsulation frame-relay” command is the cisco default type. Because the remote device in a non-cisco device then false.
D.the “encapsultion ietf” commans doesn t exist.
(it must be “encapsulation frame-relay ietf”).
The correct answear is B.
thanks!