Which Cisco Internetwork Operating System (IOS) command…

Which Cisco Internetwork Operating System (IOS) command is used to save the running configuration to non-volatile random access memory (NVRAM)?

A.
copy startup-config running-config

B.
move startup-config running-config

C.
copy running-config startup-config

D.
move startup-config running-config

Explanation:
The copy running-config startup-config command is used to save the running configuration to NVRAM. This command will should always been run after making
changes to the configuration. Failure to do so will result in the changes being discarded at the next restart of the router. When the router is restarted, the startup
configuration file is copied to RAM and becomes the running configuration.

The copy startup-config running-config command is incorrect because this command is used to copy the startup configuration to the running configuration. The
command would be used to discard changes to the configuration without restarting the router.
The move startup-config running-config and move startup-config running-config commands are incorrect because these are not valid Cisco IOS commands. There
is no move command when discussing the manipulation of configuration files.
Objective:
Infrastructure Management
Sub-Objective:
Perform device maintenance

Cisco Documentation > RPM Installation and Configuration > IOS and Configuration Basics