You have connected two routers in a lab using a Data Terminal Equipment (DTE)-to-Data Circuit-terminating
Equipment (DCE) cable.
Which command must be issued on the DCE end for the connection to function?
A.
bandwidth
B.
no clock rate
C.
clock rate
D.
no bandwidth
Explanation:
You should issue the clock rate command on the DCE end for the connection to function. The clock rate is set
on the Data Circuit-terminating Equipment (DCE) device. DCE is also known as Data Communications
Equipment.
The DCE terminates a physical WAN connection, provides clocking and synchronization of a connection
between two locations, and connects to a DTE. The DCE category includes equipment such as CSU/DSUs,
NT1s, and modems. In the real world, the clock rate is provided by the CSU/DSU end at the telcom provider. In
a lab, you must instruct the DCE end to provide a clock rate.
The DTE is an end user device, such as a router or a PC, which connects to the WAN via the DCE device.
You would not issue the bandwidth command. This command is used to inform the router of the bandwidth of
the connection for purposes of calculating best routes to locations where multiple routes exist. It is not
necessary for the link described to function.You should not issue the no clock rate command. This command is used to remove any previous settings
implemented with the clock rate command.
You would not issue the no bandwidth command. This command is used to remove any previous settings
implemented with the bandwidth command
Objective:
WAN Technologies
Sub-Objective:
Describe WAN access connectivity optionsCisco > Support > Product Support > End-of-Sale and End-of-Life Products > Cisco IOS Software Releases
11.1 > Configure > Feature Guides > Clock Rate Command Enhancements Feature Module
CCNA ICND2 Official Exam Certification Guide (Cisco Press, ISBN 1-58720-181-X), Chapter 12: Point-to-Point
WANs, pp. 446-447.