Which command is used to disable Cisco Discovery Protoc…

Which command is used to disable Cisco Discovery Protocol (CDP) on a Cisco router?

A.
disable cdp

B.
no cdp run

C.
no cdp enable

D.
no cdp advertise-v2

Explanation:
The no cdp run command is used to disable CDP on a Cisco router globally. CDP is a Layer 2 (Data Link layer)
protocol that discovers information about neighboring network devices. CDP does not use network layer
protocols to transmit information because it operates at the Data Link layer. Therefore, it is useful to determine
information about directly connected Cisco network devices, because it can operate when network protocols
have not been configured or are misconfigured. The show cdp neighbors detail command is used to view the IP
addresses of the directly connected Cisco devices.
The no cdp advertise-v2 command disables CDPv2 advertisements. It will not disable the protocol globally.
The no cdp enable command is used to disable CDP on an interface. In a situation where CDP needs to be
disabled on a single interface only, such as the interface leading to the Internet, this command would be
executed from interface configuration mode for that specific interface. It will not disable the protocol globally.
For example, to disable CDP for only the serial0 interface, the command sequence would be:
Router#configure terminal
Router(config)#interface serial 0
Router(config-if)no cdp enable
The disable cdp command is not a valid Cisco command.
Objective:
LAN Switching Fundamentals
Sub-Objective:
Configure and verify Layer 2 protocols

Cisco > Cisco IOS Network Management Command Reference > show cdp neighbors