What command produced the preceding output?
A.
show ip process
B.
show ip route
C.
show ip protocols
D.
show ip routing process
Explanation:
The show ip protocols command is used to view the current state of active routing protocols. This command is
issued from Privileged EXEC mode. It has the following syntax:
Router# show ip protocols
This command does not have any parameters.
The output was not produced by the command show ip process or the show ip routing process. The show ip
routing process and show ip process commands are incorrect because these are not valid Cisco IOS
commands.
The output was not produced by the command show ip route. The show ip route command is is used to view
the current state of the routing table. An example of the output is shown below.
Objective:
Routing Fundamentals
Sub-Objective:
Interpret the components of routing tableCisco > Support > Cisco IOS IP Routing: Protocol-Independent Command Reference > show ip protocols
