You need to set the Telnet password to “john” on a Cisco router. Which set of commands would you use?
A.
Router(config)#line vty 0 4
Router(config-line)#login
Router(config-line)#password john
B.
Router(config)#line con 0
Router(config-line)#login
Router(config-line)#password john
C.
Router(config)#line vty 0 4
Router(config-line)#login
Router(config-line)#enable secret john
D.
Router(config)#line con 0
Router(config-line)#login
Router(config-line)#enable password john
Explanation:
The set of commands which would be used to configure the Telnet password to “john” on a Cisco router is:
Router(config)#line vty 0 4
Router(config-line)#login
Router(config-line)#password john
The line vty command is used to configure the router to enable Telnet access. By using this command, the
router can be configured to accept one or more Telnet sessions.
The login and password parameters are the line configuration commands used to configure the password. The
password command specifies the password and the login command instructs the router to require the
password. By default, the login parameter is present in the configuration of the VTY lines. Because its presence
indicates that a password is required for connecting to the VTY lines, if a password has not been configured on
the VTY lines, a connection cannot be made. If an attempt were made to connect to the VTY line with the login
parameter in effect and no password present, the following error message would be generated:
Router2# telnet 10.3.1.1
Trying 10.3.1.1Open
Password Required, but none set
[Connection to 10.3.1.1 closed by foreign host]
Router2#
The following set of commands would be used to configure the console password on a Cisco router, and so it is
incorrect for this scenario.
Router(config)# line con 0
Router(config-line)# login
Router(config-line)# password john
The commands enable secret john and enable password john would be used to configure the enable secret
password and the enable password for the router. However, they cannot be used to configure the Telnet
password. Therefore, these options are incorrect.
Objective:
Infrastructure Management
Sub-Objective:
Configure and verify device management