which network layer would a branch office connect to using a private WAN?

A network engineer is following the Cisco enterprise architecture model. To which network layer
would a branch office connect to using a private WAN?

A network engineer is following the Cisco enterprise architecture model. To which network layer
would a branch office connect to using a private WAN?

A.
Enterprise Campus

B.
Enterprise Edge

C.
SP Edge Premise

D.
Remote Module

Show Hint

Leave a Reply 2

Your email address will not be published. Required fields are marked *

Micheal LN

Micheal LN

New 200-310 Exam Questions and Answers Updated Recently (14/Apr/2017):

NEW QUESTION 298
Which statement about modular network design is true?

A. It is complex and should be used only in specialized situations
B. Each deployed module is identical to the others,simplifiying configuration
C. It is flexible architecture that simplify design,management and troubleshooting
D. Each module include access,distribution and core layers

Answer: C

NEW QUESTION 299
When designing changes to an existing network, which two options are documented to understand environmental constraint? (Choose two.)

A. Utilization of network resources
B. Floor and rack space availability
C. Host naming conventions
D. Heating and Air conditioning
E. Location of existing documentation

Answer: BD

NEW QUESTION 300
In the traditional hierarchical LAN design,Which two statement about the distribution layer are true? (Choose two.)

A. It typically is connected directly to the internet It provides users direct access to the network
B. It uses Layer 2 switching only
C. It aggregates data from the access layer
D. Policy is implemented at this layer

Answer: D

NEW QUESTION 301
Which level needed to be set on Cisco WLC for VolP traffic?

A. PLATINUM
B. GOLD
C. SILVER
D. BRONZE

Answer: A

NEW QUESTION 302
Choose considerations for access layer design? (Choose two.)

A. QOS
B. Routing
C. Port security
D. Load balance
E. HSRP

Answer: AC

NEW QUESTION 303
For a VLAN that requires 60 hosts, which subnet is the most efficient?

A. 10.0.0.1/20
B. 172.31.17.0/27
C. 10.10.10.0/26
D. 192.168.15.0/24

Answer: C

NEW QUESTION 304
Which option is an advantage of a Layer 3 access model over the traditional Layer 2 access model?

A. Increased neighbor adjacencies
B. Faster convergence
C. Reduced resources on the router
D. Reduced size of routing table

Answer: B

NEW QUESTION 305
……

P.S. These New 200-310 Exam Questions Were Just Updated From The Real 200-310 Exam, You Can Get The Newest 200-310 Dumps In PDF And VCE From — http://www.passleader.com/200-310.html (326q VCE and PDF)

Good Luck!

Reply