Which of the following commands or command sets should you issue to configure a Cisco TelePresence
System 1000 with IP address 192.168.1.43, subnet mask 255.255.255.0, and default gateway 192.168.1.1?
A.
static 192.168.1.43 255.255.255.0 192.168.1.1
B.
ip address 192.168.1.43 255.255.255.0 192.168.1.1
C.
set network ip static 192.168.1.43 255.255.255.0 192.168.1.1
D.
xConfiguration Network 1 IPv4 Address: “192.168.1.43”
xConfiguration Network 1 IPv4 SubnetMask: “255.255.255.0”
xConfiguration Network 1 IPv4 Gateway: “192.168.1.1”
E.
ip address 192.168.1.43 255.255.255.0
ip defaultgateway 192.168.1.1
Explanation:
You should issue the set network ip static 192.168.1.43 255.255.255.0 192.168.1.1 command. The syntax of
the set network ip static command is set network ip static ip-address subnet-mask default-gateway
[dnsaddress1] [dnsaddress2] [domain]. After you configure the static IP address, the Cisco TelePresence
System (CTS) 1000 will automatically restart.
You can also configure a static IP address on a CTS 1000 by using the web interface. To configure a static IP
address by using the web interface, navigate to Configuration > IP Settings, change DHCP Enabled to No, and
configure the IP address, subnet mask, and default gateway fields.
You should not issue the static 192.168.1.43 255.255.255.0 192.168.1.1 command. The static command
configures a static IP address for a port on the Cisco TelePresence multipoint control unit (MCU) 5300. The
syntax of the static command is static port ip-address subnet-mask [default-gateway], where port is A for Port A
or B for Port B.
You should not issue the ip address 192.168.1.43 255.255.255.0 192.168.1.1command. The ip address
command is not valid on a CTS 1000.
You should not issue the following command set:
xConfiguration Network 1 IPv4 Address: “192.168.1.43”
xConfiguration Network 1 IPv4 SubnetMask: “255.255.255.0”
xConfiguration Network 1 IPv4 Gateway: “192.168.1.1”
You would issue these commands to configure a static IP address on a CTS Codec, such as the C40 or C60.
You should not issue the following command set:
ip address 192.168.1.43 255.255.255.0
ip defaultgateway 192.168.1.1
This command set is similar to the IP address configuration of a Cisco router or switch. However, these
commands are not valid on a CTS 1000.Cisco: Configuring the Cisco TelePresence System: Configuring a Static IP Address for Networks That Do Not
Use DHCP