You want to configure a static IP address on a CTS 1000. You connect your laptop to the auxiliary network port.
However, you are unable to connect to the system by using SSH.
Which of the following statements correctly diagnoses the problem?
A.
Your laptop should be configured to use DHCP.
B.
You cannot connect to a CTS 1000 by using SSH.
C.
You cannot configure a static IP address on a CTS 1000.
D.
You cannot administer a CTS 1000 by connecting to the auxiliary network port.
Explanation:
Your laptop should be configured to use Dynamic Host Configuration Protocol (DHCP), which will enable it to
receive a dynamic IP address from the Cisco TelePresence System (CTS) 1000. To administer the CTS 1000,
you must connect your computer to the auxiliary network port, which is the secondary camera port of the
primary codec. After your laptop has received a dynamic IP address, you should establish a Secure Shell (SSH)
connection to the CTS 1000, which will be using the first IP address in the same subnet as your laptop. For
example, if your laptop has been assigned the IP address 192.168.1.2, you should connect to IP address
192.168.1.1.
To configure a static IP address by using the command-line interface (CLI), issue the set network ip static ipaddress subnet-mask default-gateway [dnsaddress1] [dnsaddress2] [domain] command. To configure a static
IP address by using the web interface, navigate to Configuration > IP Settings, change DHCP Enabled to No,
and configure the IP address, subnet mask, and default gateway fields. After you configure the static IP
address, the CTS 1000 will automatically restart.Cisco: Configuring the Cisco TelePresence System: Configuring a Static IP Address for Networks That Do Not
Use DHCP