By default, which of the following TelePresence TX system components is polled by SNMP?
A.
the left display
B.
the center display
C.
the right display
D.
the presentation display
Explanation:
By default, the center display is polled by Simple Network Management Protocol (SNMP). SNMP can be used
to automate the monitoring of Cisco TelePresence TX systems. Only peripherals that are connected to the TS1
codec, such as the center camera and center display, are polled by SNMP by default. You can poll the TS2,
TS3, or TS4 codecs by issuing SNMP commands. Typically, the left display is connected to the TS2 codec, the
right display is connected to the TS3 codec, and the presentation display is connected to the TS4 codec.
To poll the TS2 codec by using SNMP version 3 (SNMPv3), you should issue the snmpwalk -n cts2 -v3 –m ALL
–u admin A snmp-auth-password system-ip-address object-id command. To poll the TS2 codec by using
SNMP version 2c (SNMPv2c), you should issue the snmpwalk -m ALL v2c -c community-string_cts2 system-ipaddress object-id command.Cisco: MIBs, RFCs, and SNMP Trap Messages for the Cisco TelePresence System