Which of the following commands should you issue to manually configure an IP address on Ethernet Port A on
a Cisco TelePresence MCU 5300 Series device?
A.
dhcp
B.
dns
C.
ethertype
D.
static
E.
status
Explanation:
You should issue the static command to manually configure an IP address on Ethernet Port A on a Cisco
TelePresence multipoint control unit (MCU) 5300 Series device. The syntax of the static command is static port
ip-address net-mask [default-gateway]. For example, to assign address 10.20.30.40/24 on Port A with default
gateway 10.20.30.1, you should issue the static A 10.20.30.40 255.255.255.0 10.20.30.1 command.
You should issue the dhcp command to dynamically configure an IP address on Ethernet Port A by using a
Dynamic Host Configuration Protocol (DHCP) server. For example, to configure DHCP to dynamically assign
an IPv4 address to Port A, you should issue the dhcp -4 A command.
You should issue the dns command to statically configure a Domain Name System (DNS) server address. The
syntax of the dns command is dns primary-server-address [secondary-server-address] [domain].
You should issue the ethertype command to configure speed and duplex settings on Ethernet Port A. To
configure Port A to use autosensing mode, you should issue the ethertype A auto command. To manually
configure Port A with speed or duplex settings, you should issue the ethertype A [10 | 100] [half | full] command.
You should issue the status command to display the current configuration and status of the Ethernet ports.
Speed, duplex, and static or dynamic IP address information is displayed by the status command.Cisco: Cisco TelePresence MCU 5300 Series: Getting started (PDF)