In order for Cisco Unified Presence to show the presence status of an IP phone, which two
configuration steps must be completed in the Cisco Unified Communications Manager
server? (Choose two.)
A.
Check the Allow Presence Status check box.
B.
Associate the end device with the user.
C.
Allow the SIP publish trunk to forward presence status messages.
D.
Associate the directory number with the user.
E.
Enable Cisco Unified Personal Communicator Status flag.
I Wrote my 300-085 exam yesterday, scored 970/1000!
Got 60 questions in total, most of them were new questions, including Cisco TMS, Cisco VCS and so on.
I learned all new 300-085 exam questions from passleader 300-085 exam dumps (pdf and vce dumps all available here: https://tr.im/ELLlc), all new questions were valid!!!
Some new questions (I listed them according to my real test, FYI):
QUESTION 1
Which CCC action applies only to the Cisco TelePresence MPS Series?
A. block fast update requests
B. Status Duo Video
C. move back
D. release floor
QUESTION 2
Which protocol is prioritized by Cisco TMS for conferencing?
A. SIP
B. MGCP
C. H.323
D. SCCP
QUESTION 3
How does Cisco TMS set up a call with an endpoint that is registered with Cisco Unified Communications Manager and that is connected to Cisco VCS?
A. Cisco TMS uses an IP dialing plan.
B. Cisco TMS uses a SIP trunk.
C. Cisco TMS removes the top-level domain from calls that go through Cisco Unified Communications Manager.
D. Cisco TMS drops the call, because it can verify that the trunk between Cisco Unified Communications Manager and Cisco VCS is down.
QUESTION 4
On Cisco TelePresence Management Suite, which two call control devices are supported for call control and setup? (Choose two.)
A. Cisco Unified Communications Manager Express
B. Cisco TelePresence Video Communication Server
C. Cisco Unified Border Element
D. Cisco Unified Communications Manager
E. any SIP-capable call control system
QUESTION 5
Which three are valid system connectivity statuses for systems that are automatically added to Cisco TelePresence Management Suite? (Choose three.)
A. Inaccessible
B. Failed
C. Connected
D. Reachable on Public Internet
E. Behind Firewall
F. Online
G. Remote Site
QUESTION 6
To have a Provisioning menu section available on Cisco TelePresence Management Suite, what must you do?
A. You must configure an active ISDN zone.
B. You must install Cisco TelePresence Management Suite Provisioning Extension and activate it on the system.
C. You must license Cisco TelePresence Management Suite Analytics Extension.
D. You must set up Cisco TelePresence deployment to support Cisco CMR Hybrid.
QUESTION 7
Which two actions must you take to enable provisioning on Cisco TMS and Cisco VCS? (Choose two.)
A. Apply a Device Provisioning option key on Cisco VCS.
B. Enable provisioning on Cisco VCS under Applications > Provisioning.
C. Configure Users, FindMe, Phonebooks, and Devices individually, as these all have different settings.
D. Configure a separate server to run provisioning extension services.
E. Ensure that a service account is able to connect.
F. Set the polling intervals on Users, FindMe, Phonebooks, and Devices to the same value, in order for the synchronization to work.
QUESTION 8
What must you do to activate the provisioning feature on a Cisco VCS endpoint?
A. Install the Device Provisioning option key.
B. Set a SIP trunk between Cisco VCS and Cisco Unified Communications Manager.
C. Add the Cisco VCS on the Cisco TMS, and enable Cisco Extension Mobility.
D. Install Cisco VCS Starter Pack Express.
QUESTION 9
Refer to the exhibit. Which statement about the jabber-config.xml partial output is true?
A. 10.255.10.10 is the LDAP server address.
B. The client connects to the directory server by using SSH.
C. 10.255.10.10 is the Cisco Unified Communications Manager IM and Presence Service address.
D. The client connects to the directory server by using HTTPS.
QUESTION 10
The UDS for contact resolution is enabled in the service profile configuration of the Cisco Unified Communications Manager. Which action can you execute with your Jabber Desktop?
A. modify users
B. search users
C. change users
D. delete users
QUESTION 11
Which profile must you add to an end user record, if the end user wants to access voicemail and wants to control a deskphone via CTI with Cisco Jabber?
A. remote destination profile
B. device profile
C. SIP profile
D. service profile
E. phone service
……more……
Good Luck!
New 300-085 Exam Questions and Answers Updated Recently (23/Feb/2016):
NEW QUESTION 111
Which file are the DNS SRV records kept in within the Jabber client program files?
A. DNS-records.xml
B. jabberLocalConfig.xml
C. installationid.txt
D. service-location.xml
E. jabber-config.xml
F. csf-unified.txt
Answer: D
NEW QUESTION 112
A user reports that when calling an auto-attendant, they receive a fast busy signal. Which two options can cause this issue? (Choose two.)
A. An improperly configured dial peer is in the Cisco Unified CME.
B. The auto-attendant service is not running.
C. No call-in number is specified for the auto-attendant.
D. A prompt is missing in the auto-attendant.
E. An improperlyconfigured ephone-dn is in the Cisco Unified CME.
Answer: AC
NEW QUESTION 113
You are trying to add Cisco VCS to Cisco TMS, but the addition is failing. Which three scenarios might be causing this failure? (Choose three.)
A. Cisco TMS is running a version earlier than 12.5.
B. Cisco TMS was not upgraded before adding Cisco VCS.
C. Cisco TMS and Cisco VCS do not have synchronized time settings.
D. SNMP is not enabled on Cisco VCS.
E. UDP port 161 is blocked on the network.
F. The management address on Cisco VCS does not match the Cisco TMS IP address.
Answer: DEF
NEW QUESTION 114
Which two protocols permit collection information over user’s availability status? (Choose two.)
A. SIMPLE
B. XMPP
C. LDAP
D. SOAP
Answer: AB
NEW QUESTION 115
When a user passwordis changed on Cisco Unified Communications Manager Express, how is that change propagated to Cisco Unity Express?
A. The change is automatic; there is no Cisco Unity Express administrator intervention required.
B. The user password in Cisco Unity Expressdoes not need to match the user password in Cisco Unified Communications Manager Express because they are separate systems.
C. The Cisco Unity Express administrator needs to change the password and PIN every time a change is made to the user account in Cisco Unified Communications Manager Express.
D. The Cisco Unity Express administrator needs to synchronize the user account in Cisco Unified Communications Manager Express by importing the user again.
E. The Cisco Unity Express administrator needs to change the user password to match the password in Cisco Unified Communications Manager Express.
Answer: E
NEW QUESTION 116
A user that is logged into Cisco Jabber reports that their availability status is incorrect for most of the contacts in their contact list. Which four service traces give a correct indication of the issue? (Choosefour.)
A. Cisco XCP Connection Manager
B. Cisco XCP Router
C. Cisco Presence Engine
D. Cisco SIP Proxy
E. Cisco Text Conferencing Manager
F. Cisco Client Profile Agent
G. Cisco XCP Web Connection Manager
Answer: ABCE
NEW QUESTION 117
Which protocol enables VCS-C system to be discovered by Cisco TMS?
A. HTTP
B. CDP
C. SOAP
D. SNMP
E. XMPP
Answer: D
NEW QUESTION 118
In Cisco Unity Connection, which two elements are used to provide call management? (Choose two.)
A. Call Handlers
B. Directory Handlers
C. Route Patterns
D. Hunt Lists
E. Translation patterns
Answer: AB
NEW QUESTION 119
An engineer is setting up provisioning in VCS. Which two components must be in place? (Choose two.)
A. No-charge option key for the VCS Control appliance
B. One or more Movi option keys
C. SMTP server that accepts relay from the TMS server
D. A service account in Active Directory
E. An external AD server that supports secure connections
Answer: AB
NEW QUESTION 120
You must createa services profile in Cisco Unified Communications Manager as part of the Jabber configuration. Which option is a UC service type?
A. VPIM
B. XML
C. CTI
D. LADP
Answer: C
NEW QUESTION 121
An engineer is creating a new cluster in TMS and has selected “Enable Provisioning.” The following error message is seen: “Verify that the tmsprovisioningservice is running.” What are two reasons for this issue?
A. There is a space in the VCS system name
B. Movi option key has not beenadded to the Cisco TMS
C. SNMP has not been enabled on VCS
D. UPD Port 161 has been blocked on the network
E. The management address on the VCS does not match the TMS IP address
Answer: AB
NEW QUESTION 122
……
P.S. These New 300-085 Exam Questions Were Just Updated From The Real 300-085 Exam, You Can Get The Newest 300-085 Dumps In PDF And VCE From — http://j.mp/1oyQrbA (146q)
Good Luck !!!