which statement is true?

Refer to the exhibit. Router R1 is connected to networks 172.16.1.0 /26 and 172.16.1.64 /27.
On the basis of the partial output in the exhibit, which statement is true?

Refer to the exhibit. Router R1 is connected to networks 172.16.1.0 /26 and 172.16.1.64 /27.
On the basis of the partial output in the exhibit, which statement is true?

A.
Router R1 will deny the 172.16.1.0/26 route while permitting the 172.16.1.64/27 route to
be advertised.

B.
Router R1 will advertise both routes.

C.
Router R1 should be reconfigured with an ACL instead of an ip prefix-list command.

D.
Router R1 will deny the 172.16.1.0/27 route while permitting the 172.16.1.0/26 route to be
advertised.

Show Hint

Leave a Reply 2

Your email address will not be published. Required fields are marked *

Levo

Levo

QUESTION
A network engineer is considering enabling load balancing with EIGRP.
Which consideration should be analyzed?

A. EIGRP allows a maximum of four paths across for load balancing traffic.
B. By default, EIGRP uses a default variance of 2 for load balancing.
C. EIGRP unequal path load balancing can result in routing loops.
D. By default, EIGRP performs equal cost load balancing at least across four equal cost paths.

Answer: D

QUESTION
The OSPF database of a router shows LSA types 1, 2, 3, and 7 only.
Which type of area is this router connected to?

A. stub area
B. totally stubby area
C. backbone area
D. not-so-stubby area

Answer: D

QUESTION
An engineer is configuring a GRE tunnel interface in the default mode. The engineer has assigned an IPv4 address on the tunnel and sourced the tunnel from an Ethernet interface. Which option also is required on the tunnel interface before it is operational?

A. tunnel destination address
B. keepalives
C. IPv6 address
D. tunnel protection

Answer: A

QUESTION
Which protocol is used in a DMVPN network to map physical IP addresses to logical IP addresses?

A. BGP
B. LLDP
C. EIGRP
D. NHRP

Answer: D

QUESTION
Which two routing protocols are supported by Easy Virtual Network? (Choose two.)

A. RIPv2
B. OSPFv2
C. BGP
D. EIGRP
E. IS-IS

Answer: BD

QUESTION
Which statement is true?

A. RADIUS uses TCP, and TACACS+ uses UDP.
B. RADIUS encrypts the entire body of the packet.
C. TACACS+ encrypts only the password portion of a packet.
D. TACACS+ separates authentication and authorization.

Answer: D

QUESTION
Which two statements about AAA implementation in a Cisco router are true? (Choose two.)

A. RADIUS is more flexible than TACACS+ in router management.
B. RADIUS and TACACS+ allow accounting of commands.
C. RADIUS and TACACS+ encrypt the entire body of the packet.
D. RADIUS and TACACS+ are client/server AAA protocols.
E. Neither RADIUS nor TACACS+ allow for accounting of commands.

Answer: BD

QUESTION
Which option is invalid when configuring Unicast Reverse Path Forwarding?

A. allow self ping to router
B. allow default route
C. allow based on ACL match
D. source reachable via both

Answer: D

Reply