Refer to the exhibit.
EIGRP has been configured on all routers in the network. What
additional configuration statement should be included on router R4 to advertise a default
route to its neighbors?
A.
R4(config)# ip route 0.0.0.0 0.0.0.0 10.1.1.1
B.
R4(config)# ip default-network 10.0.0.0
C.
R4(config-router)# default-information originate
D.
R4(config)# ip route 10.0.0.0 255.0.0.0 10.1.1.1
Explanation:
Unlike the ip default-gateway command, you can use ip default-network when ip routing is
enabled on the Cisco router. When you configure ip default-network the router considers
routes to that network for installation as the gateway of last resort on the router.
For every network configured with ip default-network, if a router has a route to that network,
that route is flagged as a candidate default route.
Gateways of last resort selected using the ip default-network command are propagated
differently depending on which routing protocol is propagating the default route. For IGRP
and EIGRP to propagate the route, the network specified by the ip default-network command
must be known to IGRP or EIGRP. This means the network must be an IGRP- or EIGRPderived network in the routing table, or the static route used to generate the route to the
network must be redistributed into IGRP or EIGRP, or advertised into these protocols using
the network command. In this case, the 10.0.0.0 network is indeed being advertised via EIGRP.
Reference:
http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a0080094374.shtml#ipnetwork
300-101 was Not this material
I did all 653 questions 3 times each and drilled
Scored 709/1000 on conceptual understanding but was aware how far it has changed this year
Study
Acl
Snmpv3 detail a syntax grind
PPPoE extensively
eVN trunks and tunnel details
Ip helper-address (syntax grind)
Ntp
Ndp
IPv6 eui-64 and tunneling
And I saw a lot about IPSec and DMVPN
And all the BSCI sim are included
I had 7 sim but no drag drop
THE ABOVE POST IS 100% CORRECT. THIS IS NOT THE EXAM AT ALL!!!
Took the exam today and failed. I studied all 654 questions. Went over them 7 times and memorized every single one of them. The exam had 50 questions and required a 790 to pass.
NOT A SINGLE ONE OF THESE QUESTIONS WAS ON THAT EXAM!
This are all good questions to study for the exam, but YOU WILL NOT see a single one of these questions on your actual exam. Please update these questions.
I failed the Cisco IP Routing exam after I used some free study guides found online. I was lucky enough to find cisexams and preparing with their study Material helped me clear my Pass4sure 300-101 exam with a very high score.
How exactly did you do that when Cisexams only has the really old 640-XX cisco exams that are no longer valid, and Pass4sure doesn’t offer anything for this exam???
LABs/SIMs: EIGRP Stub and EIGRP OSPF Redistribution, Policy Based Routing, OSPF Evaluation
Wrote exam yesterday and passed with 980/1000.
Learned all questions from PassLeader 300-101 dumps — http://www.passleader.com/300-101.html, 100% valid!
Good Luck!
Hi ALL!
Just passed the 300-101 yesterday!! Scored: 9xx/1000.
Network Principles: 9x%
Layer 2 Technologies: 8x%
Layer 3 Technologies: 9x%
VPN Technologies: 100%
Infrastructure Security: 100%
Infrastructure Services: 100%
Total 49 Questitons, including 44 common Qs and 5 LABs.
5 LABs:
1. OSPF Simulation
2. PBR
3. OSPFv3
4. OSPF Evaluation
5. Redistribution
I learned all questions from the newest PassLeader 230q dumps (http://www.passleader.com/300-101.html), all NEW questions are available in it now, 100% pass ensure!
P.S.
Here are PL (230q) 300-101 dumps: http://www.ciscobraindump.com/?s=300-101
Good Luck!!!
I don’t think this is correct. R4 should have the classfull A network ( 10.0.0.0/8 ) in the routing table first and It doesn’t. If we leave out “no auto-summary” then that would be true.
Correct Answers: B
Dumps4download.co.in provide you free 300-101 dumps certifications exam system which helps you to prepare your exam in short time, the dumps they provide are 100% actual and verified visit this site and prepare your exam. Visit us for more information our customer care and live chat support on 24/7.
For More Info: https://www.dumps4download.co.in/free-300-101-practice-questions.html
New 300-101 Exam Questions and Answers Updated Recently (2/June/2017):
NEW QUESTION 296
Which type of access list allows granular session filtering for upper-level protocols?
A. content-based access lists
B. context-based access lists
C. reglexive access lists
D. extended access lists
Answer: D
NEW QUESTION 297
Which three configuration parameters can a DHCPV6 pool contain? (Choose three.)
A. domain search list
B. router IP
C. default gateway
D. prefix delegation
E. DNS servers
F. subnet mask
Answer: DEF
NEW QUESTION 298
Which statement about local policy routing is true?
A. It is used to policy route packets that are generated by the device.
B. It requires all packets to be packet switched.
C. It is used to policy route packets that pass through the device.
D. It requires all packets to be CEF switched.
E. It supports IPv4 packets only.
F. It requires an ip address or access list as the matching criteria.
Answer: A
NEW QUESTION 299
Which SNMP verification command shows the encryption and authentication protocols that are used in SNMPV3?
A. show snmp group
B. show snmp user
C. show snmp
D. show snmp view
Answer: B
NEW QUESTION 300
Which type of information is displayed when a network engineer executes the show track 1 command on the router?
A. information about tracking list 1.
B. time to next poll for track object 1.
C. information about the IP route track table.
D. tracking information statistics.
Answer: A
NEW QUESTION 301
Which command sequence can you enter on a router to configure Unicast Reverse Path Forwarding in loose mode?
A. interface GigabitEthernet0/0
ip verigy unicast source reachable-via all
B. interface GigabitEthernet0/0
ip verigy unicast source reachable-via loose
C. interface GigabitEthernet0/0
ip verigy unicast source reachable-via any
D. interface GigabitEthernet0/0
ip verigy unicast source reachable-via rx
Answer: C
NEW QUESTION 302
Where can NetFlow export data for long term storage and analysis?
A. syslog
B. collector
C. another network device
D. flat file
Answer: B
NEW QUESTION 303
Which option is the first task that a device that is configured with NAT64 performs when it receives an incoming IPv6 packet that matches the stateful NAT64 prefix?
A. It translates the IPv6 header into an IPv4 header.
B. It checks the IPv6 packet against the NAT64 stateful prefix.
C. It translates the IPv6 source address to an IPv4 header.
D. It translates the^ IPv4 destination address into a new NAT64 state.
E. It performs an IPv6 route lookup.
Answer: A
NEW QUESTION 304
Which command do you enter to display log messages with a timestamp that includes the length of time since the device was last rebooted?
A. service timestamps log uptime
B. logging facility 20
C. service timestamps debugging localtime msec
D. logging console errors
E. logging monitor 7
F. service timestamps log datetime msec
Answer: A
NEW QUESTION 305
Which option must be configured on a target device to use time stamping to accurately represent response times using IP SLA?
A. Responder
B. Jitter value
C. TCP Connect
D. ICMP Echo
Answer: D
NEW QUESTION 306
Refer to the exhibit. Which option describes why the EIGRP neighbors of this router are not learning routes that are received from OSPF?
router eigrp 1
redistribute ospf 100
network 10.10.10.0 0.0.0.255
auto-summary
!
router ospf 100
network 172.16.0.0 0.0.255.255 area 100
redistribute eigrp 1
A. The subnet defined in OSPF is not part of area 0.
B. Default metrics are not configured under EIGRP.
C. There is no overlap in the subnets advertised.
D. The routing protocols do not have the same AS number.
Answer: B
NEW QUESTION 307
Which two options are requirements for EIGRP authentication? (Choose two.)
A. A crypto map must be configured.
B. The Authentication key must be configured under the interface running EIGRP.
C. The authentication key must be configured within the EIGRP routing configuration.
D. The authentication key IDs must match between two neighbors.
E. A separate key chain must be configured.
F. AN IPsec profile must be configured.
Answer: BD
NEW QUESTION 308
A network engineer is troubleshooting connectivity issues with a directly connected RIPng neighbor. Which command should directly connected RIPng neighbor adjacencies only?
A. router#show ipv6 rip next-hops
B. router#show ip rip neighbors
C. router#show ipv6 routers
D. router#show ipv6 rip database
Answer: A
NEW QUESTION 309
Which security feature can you enable to control access to the vty lines on a router?
A. exec-time out
B. logging
C. username and password
D. transport output
Answer: C
NEW QUESTION 310
A network engineer wants an NTP clients to be able to update the local system without updating or synchronizing with the remote system. Which option for the ntp access-group command is needed to accomplish this?
A. serve
B. query-only
C. serve-only
D. peer
Answer: A
NEW QUESTION 311
……
P.S. These New 300-101 Exam Questions Were Just Updated From The Real 300-101 Exam, You Can Get The Newest 300-101 Dumps In PDF And VCE From — http://www.passleader.com/300-101.html (332q VCE and PDF)
Good Luck!
Besides, part of the new 332Q 300-101 dumps are available here:
https://drive.google.com/open?id=0B-ob6L_QjGLpZEE0S2YxR3ZMUWs
Best Regards!
Besides, part of the new 300-115 dumps are available here:
http://www.ciscobraindump.com/?s=300-115
Best Regards!
Besides, part of the new 300-135 dumps are available here:
http://www.ciscobraindump.com/?s=300-135
Best Regards!
New 300-101 Exam Questions and Answers Updated Recently (2/Nov/2017):
NEW QUESTION 465
Which value does Frame Relay use to identify a connection between a DTE and DCE?
A. DLCI
B. IP address
C. MAC address
D. VLAN ID
Answer: A
NEW QUESTION 466
Which two options are limitations of Stateful NAT64? (Choose two.)
A. it is unable to route VRF traffic
B. it is unable to route multicast traffic
C. it supports FTP traffic only with an ALG
D. it supports DNS64 only
E. layer 4 supports TCP only
Answer: AB
NEW QUESTION 467
If you want to migrate an IS-IS network to another routing protocol with ……? (Choose two.)
A. UDP
B. Internal BGP
C. TCP/IP
D. EIGRP
E. OSPF
F. RIP
Answer: DE
NEW QUESTION 468
IP CEF load-sharing options ……? (Choose three.)
A. Tunnel
B. Universal
C. Include-ports
D. Source
E. Destination
Answer: ABC
NEW QUESTION 469
What is the minimum privilege level to enter all commands in usermode?
A. Level14
B. Level0
C. Level1
D. Level15
Answer: C
NEW QUESTION 470
Which two statements about password-protecting device access are true? (Choose two)
A. The more system:running-config command displays encrypted passwords in clear text.
B. The service password-encryption command forces a remote device to encrypt the password.
C. A network administrator can recover an encrypted password.
D. The privilege level command controls the commands a specific user can execute.
E. The password can be encrypted in the running configuration.
Answer: DE
NEW QUESTION 471
Frame Relay LMI autosense. Which statements are true? (Choose two.)
A. Line should be up and protocol should be down.
B. Protocol must be up.
C. It only works on DTEs.
D. It only works on DCEs.
Answer: AC
NEW QUESTION 472
Which two protocols can cause TCP starvation? (Choose two.)
A. TFTP
B. SNMP
C. SMTP
D. HTTPS
E. FTP
Answer: AB
NEW QUESTION 473
……
You Can Get The Newest 300-101 Dumps In PDF And VCE From — https://www.passleader.com/300-101.html (489q VCE and PDF)
Good Luck!
And, part of that new 489Q 300-101 dumps FYI:
https://drive.google.com/open?id=0B-ob6L_QjGLpZEE0S2YxR3ZMUWs
Regards!