A network design shows that R1 has four different possible paths from itself to the Data
Center subnets. Which of the following can influence which of those routes become feasible
successor routes, assuming that you follow the Cisco recommended practice of not
changing metric weights? (Choose two.)
A.
The configuration of EIGRP offset lists
B.
Current link loads
C.
Changing interface delay settings
D.
Configuration of variance
Explanation:
By default, the metric weights cause EIGRP to consider bandwidth and delay in the metric
calculation, so changing either bandwidth or delay impacts the calculation of the feasible
distance and reported distance, and impacts choice of feasible successor routes. Offset lists
also change the metric, which in turn can change whether a route is an FS route. Link
loading would impact the metrics, but not without changing the metric weights to
nonrecommended values. Finally, variance impacts which routes end up in the IP routing
table, but it is not considered by EIGRP when determining which routes are FS routes.
http://www.cisco.com/c/en/us/support/docs/ip/enhanced-interior-gateway-routing-protocol-eigrp/13673-14.html#modifycompositemetric
I saw a lot of answers but this is real A & C because the question is about feasible successor and you need to modify the advertise distance. An the metrics weiths refer k1-1 k2-0 k3=1 k4=0 k5=0
New 300-101 Exam Questions and Answers Updated Recently (2/Nov/2017):
NEW QUESTION 463
What is the minimum privilege level to enter all commands in usermode?
A. Level14
B. Level0
C. Level1
D. Level15
Answer: C
NEW QUESTION 464
Refer to the exhibit. How can you configure a second export destination for IP address 192.168.10.1?
configure terminal
ip flow-export destination 192.168.10.1 9991
ip flow-export version 9
A. specify a different TCP port
B. specify a different UDP port
C. specify a VRF
D. configure a version 5 flow-export to the same destination
E. specify a different flow ID
Answer: C
NEW QUESTION 465
Which value does Frame Relay use to identify a connection between a DTE and DCE?
A. DLCI
B. IP address
C. MAC address
D. VLAN ID
Answer: A
NEW QUESTION 466
Which two options are limitations of Stateful NAT64? (Choose two.)
A. it is unable to route VRF traffic
B. it is unable to route multicast traffic
C. it supports FTP traffic only with an ALG
D. it supports DNS64 only
E. layer 4 supports TCP only
Answer: AB
NEW QUESTION 467
If you want to migrate an IS-IS network to another routing protocol with ……? (Choose two.)
A. UDP
B. Internal BGP
C. TCP/IP
D. EIGRP
E. OSPF
F. RIP
Answer: DE
NEW QUESTION 468
IP CEF load-sharing options ……? (Choose three.)
A. Tunnel
B. Universal
C. Include-ports
D. Source
E. Destination
Answer: ABC
NEW QUESTION 469
……
NEW QUESTION 470
Which two statements about password-protecting device access are true? (Choose two)
A. The more system:running-config command displays encrypted passwords in clear text.
B. The service password-encryption command forces a remote device to encrypt the password.
C. A network administrator can recover an encrypted password.
D. The privilege level command controls the commands a specific user can execute.
E. The password can be encrypted in the running configuration.
Answer: DE
NEW QUESTION 471
Frame Relay LMI autosense. Which statements are true? (Choose two.)
A. Line should be up and protocol should be down.
B. Protocol must be up.
C. It only works on DTEs.
D. It only works on DCEs.
Answer: AC
NEW QUESTION 472
Which two protocols can cause TCP starvation? (Choose two.)
A. TFTP
B. SNMP
C. SMTP
D. HTTPS
E. FTP
Answer: AB
NEW QUESTION 473
……
P.S. These New 300-101 Exam Questions Were Just Updated From The Real 300-101 Exam, You Can Get The Newest 300-101 Dumps In PDF And VCE From — https://www.passleader.com/300-101.html (489q VCE and PDF)
Good Luck!
Besides, part of the new 489Q 300-101 dumps for your reference:
https://drive.google.com/open?id=0B-ob6L_QjGLpZEE0S2YxR3ZMUWs
Best Regards!