What is the maximum number of switches that can be stacked using Cisco StackWise?
A.
4
B.
5
C.
8
D.
9
E.
10
F.
13
What is the maximum number of switches that can be stacked using Cisco StackWise?
What is the maximum number of switches that can be stacked using Cisco StackWise?
The Exam has been changed on December 19 2015 for this particular Cisco Switches under CCNP
Took the 300-115 exam yesterday, passed with 955/1000 points!
Got 40 questions in total, a lot of new questions, LABs: LACP, AAAdot1x and HSRP.
I got all questions from passleader 300-115 exam dumps (got vce and pdf files from: https://tr.im/gMzjr), all new questions were same as my exam, still valid until now!
Here are some new questions that appeared in my exam:
Q1
When SDM templates are configured, which action must be performed for the configuration to take effect?
A. reload
B. shutdown
C. write memory
D. backup config
Q2
Which statement about the MAC address sticky entries in the switch when the copy run start command is entered is true?
A. A sticky MAC address is retained when the switch reboots.
B. A sticky MAC address can be a unicast or multicast address.
C. A sticky MAC address is lost when the switch reboots.
D. A sticky MAC address ages out of the MAC address table after 600 seconds.
Q3
Enablement of which feature puts the port into err-disabled state when the port has PortFast enabled and it receives BPDUs?
A. BPDU filtering
B. BackboneFast
C. EtherChannel
D. BPDU guard
Q4
Interfaces are assigned to a VLAN, and then the VLAN is deleted. Which state are these interfaces in after the VLAN is deleted?
A. They remain up, but they are reassigned to the default VLAN.
B. They go down until they are reassigned to a VLAN.
C. They go down, but they are reassigned to the default VLAN.
D. They remain up, but they are reassigned to the native VLAN.
Q5
Which feature is automatically configured when an administrator enables a voice VLAN?
A. 802.1Q trunking
B. PortFast
C. QoS
D. private VLANs
Q6
Which statement describes one major issue that VTP can cause in an enterprise network when a new switch is introduced in the network in VTP mode server?
A. It can cause network access ports to go into err-disabled state.
B. It can cause a network-wide VLAN configuration change if the revision number on the new switch is higher.
C. It can cause a network-wide VLAN configuration change if the revision number on the new switch is lower.
D. It can cause routing loops.
Good Luck To You!
I passed 7/1/16. Questions and labs are still valid.
Narian Jescu
and then what is the ANSWER for Question ?
anyway
the answer is ‘ D ‘ for main Q) – seenagape
[Update]
New 300-115 Exam Questions and Answers Updated Recently (7/Feb/2016):
NEW QUESTION 1
Refer to the exhibit, which statement abort the current configuration on port GigabitEthernet2/0/1 is true?
!
interface GigabitEthernet2/0/1
switchport access vlan 700
switchport trunk allowed vlan 200,300,700
switchport mode trunk
end
!
A. It is an access port configured for a phone and a PC
B. It is a trunk port and the native VLAN is VLAN1
C. It is a trunk port and the natrve VL AN m VLAN 700
D. It is an access port in VLAN 700
Answer: B
NEW QUESTION 2
Which two statements about default FHRP behavior are true? (Choose two.)
A. A backup GLBP active virtual gateway can become active only if the current active virtual gateway fails.
B. Preemption is enabled by default.
C. Unless specifically Configured, the priority of an HSRP router is 200.
D. A standby HSRP router becomes active if it has a higher priority than the priority of the current active router.
E. A VRRP backup virtual router becomes the master router if its priority is higher than the priority of the current master router.
Answer: DE
NEW QUESTION 3
If StormControl is enabled on a port and the traffic reachesthe configured level, which two actions can be configured to occur? (Choose two.)
A. Trap
B. notify admin
C. redirect traffic
D. log
E. shut down
Answer: AC
NEW QUESTION 4
Which two options are advantages of deploying VTPv3? (Choose two.)
A. It stores the VTP domain password securely as a SHA-1 hash.
B. It adds an FCS field at the end of each VTP frame for consistency checking.
C. It supports the propagation of private VLANs.
D. It supports the use of AES to encrypt VTP messaging.
E. It can be configured to allow only one VTP server to make changes to the VTP domain.
Answer: DE
NEW QUESTION 5
Which statement about HSRP, GLBP, and VRRP is true?
A. VRRP group members communicate using multicast address 224.0.0.102.
B. MAC address 0000.0c07.acOc indicates that default gateway redundancy is provided through GLBP.
C. HSRP group members communicate using multicast address 224.0.0.18.
D. GLBP uses UDP port 3222 (source and destination) for hello messages.
Answer: A
NEW QUESTION 6
……
P.S. These New 300-115 Exam Questions Were Just Updated From The Real 300-115 Exam, You Can Get The Newest 300-115 Dumps In PDF And VCE From — http://www.passleader.com/300-115.html (242q VCE and PDF)
Good Luck!
David:
Sorry, but you have several wrong answers to your questios, you should review them:
-On question 2 there is a mixup of info: by default, VRRP preempts but HSRP does not, so option D does not seem to be correct, although I could be wrong.
-On question 3 the answers are A and E, storm control can send a trap or shutdown (err-disable) the interface.
-On question 4 the answers are C and E, support for private vlans and and only one vtp server (primary in vtpv3 lingo), vtp messaging is not encrypted, just the password is saved as a hash in the vlan.dat file.
-On question 5 the answer is D, VRRP uses multicast 224.0.0.18 and HSRP uses 224.0.0.2 in V1 and 224.0.0.102 in V2.
Besides, that new 242Q 300-115 Dumps are Available here for Free:
https://drive.google.com/open?id=0B-ob6L_QjGLpV1dGa2Q3czNVNG8
Best Regards!