What are some virtues of implementing end-to-end VLANs? (Choose two)
A.
End-to-end VLANs are easy to manage.
B.
Users are grouped into VLANs independent of a physical location.
C.
Each VLAN has a common set of security and resource requirements for all members.
D.
Resources are restricted to a single location.
Explanation:
In an end-to-end VLAN, users are grouped into VLANs independent of physical location and
dependent on group or job function.
Each VLAN has a common set of security requirements for all members.
Incorrect Answers:
A: End to end VLANs are more difficult to manage than local VLANs, due to the physical
distances that they can span.
D: In an end-to-end VLAN, network resources are generally distributed across the entire
enterprise wide area network.
b, c
End-to-end vlans are difficult to manage? How about VTP?
I would go with A,B
C is not necessarily correct, it’s up to the architect to decide that
New 300-115 Exam Questions and Answers (4/July/2017 Updated):
NEW QUESTION 390
Which feature do you implement so that an interface enters the root inconsistent state if it receives a superior BPDU?
A. DPDU filter
B. root guard
C. BPDU guard
D. loop guard
Answer: B
NEW QUESTION 391
In which two ways can a port respond to a port-security violation? (Choose two.)
A. The port enters the en-disabled state.
B. The Security Violation counter is incremented and the port sends an SNMP trap.
C. The Security Violation counter is incremented and the port sends a critical syslog message to the console.
D. The port triggers an EEM script to notify support staff and continues to forward traffic normally.
E. The port immediately begins to drop all traffic.
F. The port enters the shutdown state.
Answer: AF
NEW QUESTION 392
Which three functions does Dynamic ARP Inspection perform with invalid IP-to MAC address bindings? (Choose three.)
A. accepts
B. deletes
C. discards
D. bypasses
E. intercepts
F. logs
Answer: CEF
NEW QUESTION 393
Which two statements about 802.1Q are true? (Choose two.)
A. It encapsulates the original Ethernet frame and adds a VLAN identifier.
B. It increases the maximum size an Ethernet frame to 1094 bytes.
C. It is a Cisco proprietary protocol.
D. When It is enabled, it forces a recalculation of the frame check sequence field.
E. It supports 8-byte VLAN identifiers.
F. It adds a 32-bit field to the Ethernet frame between the source MAC address and length fields.
Answer: DF
NEW QUESTION 394
A physical switch port is part of an EtherChannel group. What happenes while the same port configured as a SPAN destination?
A. The port forwards traffic in the EtherChannel group and acts as a SPAN source simultaneously.
B. The port is removed from the EtherChannel group.
C. The port is put in the errdisabled state and can only be reenabled manually.
D. The operation is not allowed as an EtherChannel member cannot be a SPAN source port.
Answer: D
NEW QUESTION 395
Which two statements about CDP are true? (Choose two.)
A. CDP uses a TLV to advertise the native VLAN
B. CDP is not supported with SNMP
C. CDP is supported on Frame Relay sub interfaces.
D. CDP runs on OSI layer 2
E. CDP runs on OSI layer 1
Answer: AC
NEW QUESTION 396
Which two combinations of Ether Channel modes support the formation of an EtherChannel? (Choose two.)
A. desirable, passive
B. desirable, desirable
C. active, passive
D. passive, passive
E. active, desirable
Answer: BC
NEW QUESTION 397
……
P.S. Get The Newest 300-115 Dumps In PDF And VCE From — http://www.passleader.com/300-115.html (401q VCE and PDF)
Good Luck!
By the way, that new 401Q 300-115 Dumps are Available here for Free:
https://drive.google.com/open?id=0B-ob6L_QjGLpV1dGa2Q3czNVNG8
Best Regards!