What is true about static VLANs?

Static VLANs are being used on the Company network. What is true about static VLANs?

Static VLANs are being used on the Company network. What is true about static VLANs?

A.
Devices use DHCP to request their VLAN.

B.
Attached devices are unaware of any VLANs.

C.
Devices are assigned to VLANs based on their MAC addresses.

D.
Devices are in the same VLAN regardless of which port they attach to.

Explanation:
LAN port VLAN membership can be assigned manually on a port-by-port basis. When you
assign LAN ports to VLANs using this method, it is known as port-based, or static, VLAN
membership.
Attached devices will be unaware of any VLANs.
Incorrect Answers:
A: The DHCP service is not involved in VLAN assignment.
C: Devices are not assigned to VLAN based on their MAC addresses. This is a function of
dynamic VLANs.
D: Static VLANs are configured on a port by port basis.
Configuring VLANs
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/121_8aex/swconfig/vlans.htm

Show Hint

Leave a Reply 4

Your email address will not be published. Required fields are marked *

Tomas Vave

Tomas Vave

New 300-115 Exam Questions Updated Recently (4/July/2017):

NEW QUESTION 391
In which two ways can a port respond to a port-security violation? (Choose two.)

A. The port enters the en-disabled state.
B. The Security Violation counter is incremented and the port sends an SNMP trap.
C. The Security Violation counter is incremented and the port sends a critical syslog message to the console.
D. The port triggers an EEM script to notify support staff and continues to forward traffic normally.
E. The port immediately begins to drop all traffic.
F. The port enters the shutdown state.

Answer: AF

NEW QUESTION 392
Which three functions does Dynamic ARP Inspection perform with invalid IP-to MAC address bindings? (Choose three.)

A. accepts
B. deletes
C. discards
D. bypasses
E. intercepts
F. logs

Answer: CEF

NEW QUESTION 393
Which two statements about 802.1Q are true? (Choose two.)

A. It encapsulates the original Ethernet frame and adds a VLAN identifier.
B. It increases the maximum size an Ethernet frame to 1094 bytes.
C. It is a Cisco proprietary protocol.
D. When It is enabled, it forces a recalculation of the frame check sequence field.
E. It supports 8-byte VLAN identifiers.
F. It adds a 32-bit field to the Ethernet frame between the source MAC address and length fields.

Answer: DF

NEW QUESTION 394
A physical switch port is part of an EtherChannel group. What happenes while the same port configured as a SPAN destination?

A. The port forwards traffic in the EtherChannel group and acts as a SPAN source simultaneously.
B. The port is removed from the EtherChannel group.
C. The port is put in the errdisabled state and can only be reenabled manually.
D. The operation is not allowed as an EtherChannel member cannot be a SPAN source port.

Answer: D

NEW QUESTION 395
Which two statements about CDP are true? (Choose two.)

A. CDP uses a TLV to advertise the native VLAN
B. CDP is not supported with SNMP
C. CDP is supported on Frame Relay sub interfaces.
D. CDP runs on OSI layer 2
E. CDP runs on OSI layer 1

Answer: AC

NEW QUESTION 396
Which two combinations of Ether Channel modes support the formation of an EtherChannel? (Choose two.)

A. desirable, passive
B. desirable, desirable
C. active, passive
D. passive, passive
E. active, desirable

Answer: BC

NEW QUESTION 397
……

P.S. These New 300-115 Exam Questions Were Just Updated From The Real 300-115 Exam, You Can Get The Newest 300-115 Dumps In PDF And VCE From — http://www.passleader.com/300-115.html (401q VCE and PDF)

Good Luck!

Reply