Exhibit
Which command will ensure that Company2 will be the primary router for traffic using the
gateway address of 172.16.15.20?
A.
On R2 add the command standby 1 priority 80
B.
On R1 add the command standby 1 priority 110
C.
On R1 add the command standby 1 priority 80
D.
On R2 remove the command standby 1 preempt
Explanation:
HSRP election is based on a priority value (0 to 255) that is configured on each router in the
group. By default, the priority is 100. The router with the highest priority value (255 is
highest) becomes the active router for the group. If all router priorities are equal or set to the
default value, the router with the highest IP address on the HSRP interface becomes the
active router. To set the priority, use the following interface configuration command:
Switch(config-if)# standby group priority priority
When HSRP is configured on an interface, the router progresses through a series of states
before becoming active. This forces a router to listen for others in a group and see where it
fits into the pecking order. The HSRP state sequence is Disabled, Init, Listen, Speak,
Standby, and, finally, Active.
C works but real answer is none !
Because R2 has preempt configured, both routers have the same priority, no interface tracking is configured and since R2 has the HIGHEST ip address, it will always be the active router if both routers are up.