The priority value for VLAN 105 is not explicitly configured on DSW2…

The priority value for VLAN 105 is not explicitly configured on DSW2, so it will take the
default value of 100. Use the “show standby” command to verify this on DSW2.

The priority value for VLAN 105 is not explicitly configured on DSW2, so it will take the
default value of 100. Use the “show standby” command to verify this on DSW2.

Answer: See the explanation

Explanation:

On DSW1, decrease the priority value to a value less than 190 and greater than 150.
The priority value on DSW1 is set to 200 while it is set to 190 on DSW2. Lowering the value
on DSW1 will enable DSW2 to become the primary router for VLAN 103 while enabling the
DSW1 to become active if Gig 1/0/1 is down on DSW2.

Show Hint

Leave a Reply 4

Your email address will not be published. Required fields are marked *

15 + 4 =

Rambo

Rambo

Passed today with 9xx. STP/LACP, AAA labs and HSRP sim. LLDP/CDP drag and drop. Lead2pass 230q has the correct labs and has correct answers, unlike 191q that has incorrect answer for STP/LACP lab. For one question is about stabdby HSRP address reported as duplicate. The correct answer is spanning tree loop. Hope it helps!

Reply