What is the maximum number of switches that can be stac…

What is the maximum number of switches that can be stacked using Cisco StackWise?

What is the maximum number of switches that can be stacked using Cisco StackWise?

A.
4

B.
5

C.
8

D.
9

E.
10

F.
13

Explanation:
Up to 9 Cisco Catalyst switches can be stacked together to build single logical StackWise switch since Cisco IOS XE Release 3.3.0SE. Prior to Cisco IOS XE
Release3.3.0SE, up to 4 Cisco Catalyst switches could be stacked together.
http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-3850-series- switches/qa_c67-722110.html

Show Hint

Leave a Reply 2

Your email address will not be published. Required fields are marked *

Okkar Ore

Okkar Ore

New 300-115 Exam Questions and Answers (4/July/2017 Updated):

NEW QUESTION 390
Which feature do you implement so that an interface enters the root inconsistent state if it receives a superior BPDU?

A. DPDU filter
B. root guard
C. BPDU guard
D. loop guard

Answer: B

NEW QUESTION 391
In which two ways can a port respond to a port-security violation? (Choose two.)

A. The port enters the en-disabled state.
F. The port enters the shutdown state.

NEW QUESTION 392
Which three functions does Dynamic ARP Inspection perform with invalid IP-to MAC address bindings? (Choose three.)

A. accepts
B. deletes
C. discards
D. bypasses
E. intercepts
F. logs

Answer: CEF

NEW QUESTION 393
Which two statements about 802.1Q are true? (Choose two.)

A. It encapsulates the original Ethernet frame and adds a VLAN identifier.
B. It increases the maximum size an Ethernet frame to 1094 bytes.
C. It is a Cisco proprietary protocol.
D. When It is enabled, it forces a recalculation of the frame check sequence field.
E. It supports 8-byte VLAN identifiers.
F. It adds a 32-bit field to the Ethernet frame between the source MAC address and length fields.

Answer: DF

NEW QUESTION 394
A physical switch port is part of an EtherChannel group. What happenes while the same port configured as a SPAN destination?

A. The port forwards traffic in the EtherChannel group and acts as a SPAN source simultaneously.
B. The port is removed from the EtherChannel group.
C. The port is put in the errdisabled state and can only be reenabled manually.
D. The operation is not allowed as an EtherChannel member cannot be a SPAN source port.

Answer: D

NEW QUESTION 395
Which two statements about CDP are true? (Choose two.)

A. CDP uses a TLV to advertise the native VLAN
B. CDP is not supported with SNMP
C. CDP is supported on Frame Relay sub interfaces.
D. CDP runs on OSI layer 2
E. CDP runs on OSI layer 1

Answer: AC

NEW QUESTION 396
Which two combinations of Ether Channel modes support the formation of an EtherChannel? (Choose two.)

A. desirable, passive
B. desirable, desirable
C. active, passive
D. passive, passive
E. active, desirable

Answer: BC

NEW QUESTION 397
……

Get The Newest 300-115 Dumps In PDF And VCE From — http://www.passleader.com/300-115.html (401q VCE and PDF)

Good Luck!

Reply