Refer to the exhibit.
A network engineer investigates a recent network failure and notices that one of the interfaces on the switch is still down. What is causing the line protocol on this
interface to be shown as down?
A.
There is a layer 1 physical issue.
B.
There is a speed mismatch on the interface.
C.
The interface is configured as the target of the SPAN session.
D.
The interface is configured as the source of the SPAN session.
E.
There is a duplex mismatch on the interface.
Explanation:
With the SAPN destination port, the state of the destination port is up/down by design. The interface shows the port in this state in order to make it evident that the
port is currently not usable as a production port. This is the normal operational state for SPAN destinations.http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015c612.
shtml
(4/July/2017 Updated) New 300-115 Exam Questions:
NEW QUESTION 392
Which three functions does Dynamic ARP Inspection perform with invalid IP-to MAC address bindings? (Choose three.)
A. accepts
B. deletes
C. discards
D. bypasses
E. intercepts
F. logs
Answer: CEF
NEW QUESTION 393
Which two statements about 802.1Q are true? (Choose two.)
A. It encapsulates the original Ethernet frame and adds a VLAN identifier.
B. It increases the maximum size an Ethernet frame to 1094 bytes.
C. It is a Cisco proprietary protocol.
D. When It is enabled, it forces a recalculation of the frame check sequence field.
E. It supports 8-byte VLAN identifiers.
F. It adds a 32-bit field to the Ethernet frame between the source MAC address and length fields.
Answer: DF
NEW QUESTION 394
A physical switch port is part of an EtherChannel group. What happenes while the same port configured as a SPAN destination?
A. The port forwards traffic in the EtherChannel group and acts as a SPAN source simultaneously.
B. The port is removed from the EtherChannel group.
C. The port is put in the errdisabled state and can only be reenabled manually.
D. The operation is not allowed as an EtherChannel member cannot be a SPAN source port.
Answer: D
NEW QUESTION 395
Which two statements about CDP are true? (Choose two.)
A. CDP uses a TLV to advertise the native VLAN
B. CDP is not supported with SNMP
C. CDP is supported on Frame Relay sub interfaces.
D. CDP runs on OSI layer 2
E. CDP runs on OSI layer 1
Answer: AC
NEW QUESTION 396
Which two combinations of Ether Channel modes support the formation of an EtherChannel? (Choose two.)
A. desirable, passive
B. desirable, desirable
C. active, passive
D. passive, passive
E. active, desirable
Answer: BC
NEW QUESTION 397
……
P.S. You Can Get The Newest 300-115 Dumps In PDF And VCE From — http://www.passleader.com/300-115.html (401q VCE and PDF)
Good Luck!
More, that new 401Q 300-115 Dumps are Available here for Free:
https://drive.google.com/open?id=0B-ob6L_QjGLpV1dGa2Q3czNVNG8
Best Regards!