Which SDM template is the most appropriate for a Layer …

Which SDM template is the most appropriate for a Layer 2 switch that provides connectivity to a large number of clients?

Which SDM template is the most appropriate for a Layer 2 switch that provides connectivity to a large number of clients?

A.
VLAN

B.
default

C.
access

D.
routing

Explanation:
To allocate ternary content addressable memory (TCAM) resources for different usages, the switch SDM templates prioritize system resources to optimize support
for certain features. You can select SDM templates to optimize these features:
· Access–The access template maximizes system resources for access control lists (ACLs) to accommodate a large number of ACLs.
· Default–The default template gives balance to all functions. · Routing–The routing template maximizes system resources for Ipv4 unicast routing, typically
required for a router or aggregator in the center of a network. · VLANs–The VLAN template disables routing and supports the maximum number of unicast MAC
addresses (clients). It would typically be selected for a Layer 2 switch.

http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_55_se/configur ation/guide/swsdm.pdf

Show Hint

Leave a Reply 2

Your email address will not be published. Required fields are marked *

Diana

Diana

New 300-115 Exam Questions Updated Recently (4/July/2017):

NEW QUESTION 392
Which three functions does Dynamic ARP Inspection perform with invalid IP-to MAC address bindings? (Choose three.)

A. accepts
B. deletes
C. discards
D. bypasses
E. intercepts
F. logs

Answer: CEF

NEW QUESTION 393
Which two statements about 802.1Q are true? (Choose two.)

A. It encapsulates the original Ethernet frame and adds a VLAN identifier.
B. It increases the maximum size an Ethernet frame to 1094 bytes.
C. It is a Cisco proprietary protocol.
D. When It is enabled, it forces a recalculation of the frame check sequence field.
E. It supports 8-byte VLAN identifiers.
F. It adds a 32-bit field to the Ethernet frame between the source MAC address and length fields.

Answer: DF

NEW QUESTION 394
A physical switch port is part of an EtherChannel group. What happenes while the same port configured as a SPAN destination?

A. The port forwards traffic in the EtherChannel group and acts as a SPAN source simultaneously.
B. The port is removed from the EtherChannel group.
C. The port is put in the errdisabled state and can only be reenabled manually.
D. The operation is not allowed as an EtherChannel member cannot be a SPAN source port.

Answer: D

NEW QUESTION 395
Which two statements about CDP are true? (Choose two.)

A. CDP uses a TLV to advertise the native VLAN
B. CDP is not supported with SNMP
C. CDP is supported on Frame Relay sub interfaces.
D. CDP runs on OSI layer 2
E. CDP runs on OSI layer 1

Answer: AC

NEW QUESTION 396
Which two combinations of Ether Channel modes support the formation of an EtherChannel? (Choose two.)

A. desirable, passive
B. desirable, desirable
C. active, passive
D. passive, passive
E. active, desirable

Answer: BC

NEW QUESTION 397
……

P.S. These New 300-115 Exam Questions Were Just Updated From The Real 300-115 Exam, You Can Get The Newest 300-115 Dumps In PDF And VCE From — http://www.passleader.com/300-115.html (401q VCE and PDF)

Good Luck!

Reply