Which command would a network engineer apply to error-d…

Which command would a network engineer apply to error-disable a switchport when a packet- storm is detected?

A.
router(config-if)#storm-control action shutdown

B.
router(config-if)#storm-control action trap

C.
router(config-if)#storm-control action error

D.
router(config-if)#storm-control action enable

Explanation:
Configuring the Traffic Storm Control Shutdown Mode
To configure the traffic storm control shutdown mode on an interface, perform this task:
Command

Purpose
Step 1
Router(config)# interface {{type1 slot/port} | {port-channel number}} Selects an interface to configure.
Step 2
Router(config-if)# storm-control action shutdown
(Optional) Configures traffic storm control to error-disable ports when a traffic storm occurs.
Enter the no storm-control action shutdown command to revert to the default action (drop).
·
Use the error disable detection and recovery feature, or the shutdown and no shutdown commands to reenable ports.
http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/12- 2SX/configuration/guide/book/storm.html