Which information does the subordinate switch in a swit…

Which information does the subordinate switch in a switch stack keep for all the VLANs that are configured on it?

Which information does the subordinate switch in a switch stack keep for all the VLANs that are configured on it?

A.
VLAN database

B.
DHCP snooping database

C.
spanning trees

D.
routing information

Show Hint

Leave a Reply 2

Your email address will not be published. Required fields are marked *

Levo

Levo

2018 New 300-115 Dumps with New 300-115 Questions:

QUESTION
When IP Source Guard with source IP filtering is enabled on an interface, which feature must be enabled on the access VLAN for that interface?

A. DHCP snooping
B. storm control
C. spanning-tree portfast
D. private VLAN

Answer: A

QUESTION
Which switch feature prevents traffic on a LAN from being overwhelmed by continuous multicast or broadcast traffic?

A. storm control
B. port security
C. VTP pruning
D. VLAN trunking

Answer: A

QUESTION
Which command would a network engineer apply to error-disable a switchport when a packet-storm is detected?

A. router(config-if)#storm-control action shutdown
B. router(config-if)#storm-control action trap
C. router(config-if)#storm-control action error
D. router(config-if)#storm-control action enable

Answer: A

QUESTION
When a Cisco Catalyst switch that is configured in VTP server mode is first booted, which two VLAN ranges are loaded on the switch?

A. all VLAN are in the VLAN database.
B. VLANs greater than 1005 in the startup-config file
C. the first 1005 VLANs in the VLAN database file
D. the first 1005 VLANs in the startup-config file
E. VLANs greater than 1005 in the VLAN database file

Answer: BC

QUESTION
An enterprise network has port security sticky enabled on all access ports.
A network administrator moves a PC from one office desk to another.
After the PC is moved, the network administrator clears the port security on the new network switch port connecting to the PC, but the port keeps going back into err-disabled mode.
Which two factors are possible causes of this issue? (Choose two)

A. Port security sticky exists on the new network switch port.
B. Port security sticky is disabled on the new network switch port.
C. Port security must be disabled on all access ports.
D. Port security is still enabled on the older network switch port.
E. Port security sticky is still enabled on the older network switch port.

Answer: AE

QUESTION
On which interface can port security be configured?

A. static trunk ports
B. destination port for SPAN
C. EtherChannel port group
D. dynamic access point

Answer: A

Reply