Under what circumstances should an administrator prefer local VLANs over end-to-end
VLANs?
A.
Eighty percent of traffic on the network is destined for Internet sites.
B.
There are common sets of traffic filtering requirements for workgroups located in multiple
buildings.
C.
Eighty percent of a workgroup’s traffic is to the workgroup’s own local server.
D.
Users are grouped into VLANs independent of physical location.
E.
None of the other alternatives apply
Explanation:
This geographic location can be as large as an entire building or as small as a single switch
inside a wiring closet. In a geographic VLAN structure, it is typical to find 80 percent of the
traffic remote to the user (server farms and so on) and 20 percent of the traffic local to the
user (local server, printers, and so on).
Reference: Building Cisco Multilayer Switched Networks (Cisco Press) page 93
A.- De esta forma el trafico brodcast generado no recorrera todos los SW del campus, ademas los protocolos de capa 2 tendran un menor domino, afectando menos SW al reconverger o al presentarse cambios en la topologia,
C.
Latest 300-115 Dumps PDF Free Download.v.2017-08-14.435q
QUESTION 399
Which two commands sequences must you enter on a pair switches so that they negotiate? (Choose 2)
A. channel-protocol lacp
channel-group 1 mode auto
B. channel-protocol lacp
channel-group 1 mode passive
C. channel-protocol pagp
channel-group 1 mode on
D. channel-protocol pagp
channel-group 1 mode auto
E. channel-protocol lacp
channel-group 1 mode active
Answer: BE
QUESTION 400
Which two prerequisites for HSRP to become active on an interface are true? (Choose 2)
A. Cisco Express Forwarding must be disabled globally.
B. The VIP must be in the same subnet as the primary IP address.
C. A Virtual-MAC address must be configured on the interface.
D. An IP address must be configured on the interface.
E. PIM routing must be disabled on the interface.
Answer: BD
QUESTION 401
Which two authentication types does VRRP support? (Choose Two)
A. Plain-text
B. CHAP
C. PAP
D. 802.1X
E. MD5
Answer: AE
QUESTION 402
Which two limitations of LOCAL SPAN are true? (Choose Two)
A. The source and destination ports must reside in the same switch or switch stack
B. It can monitor only traffic that ingresses or egresses on the source interface or VLAN.
C. A SPAN session can support multiple destination ports only if they are on the same VLAN.
D. EACH SPAN session supports only one source VLAN or interface.
E. A switch can support only one local SPAN session at a time.
Answer: AE
QUESTION 403
Which Statement about the default SWITCH Database Management Template is true?
A. Template disables routing and supports the maximum number of unicast MAC addresses
B. Template maximizes system resources for access control lists.
C. Template maximizes system resources for unicast routing.
D. Template gives balance to all functions
Answer: D
QUESTION 404
Which results happens when a non-trunking port that is configured with BPDU guard is connected to a device that is transmitting?
A. The port is moved into the spanning-tree blocking state.
B. There port is error-disabled.
C. A routing loop can occur on the network.
D. The port transitions to the connected state.
Answer: B
QUESTION 405
Which two settings are the parts of a Default LLDP configuration? (Choose Two)
A. The LLDP hold time is 60 seconds.
B. The LLDP global state is Disabled.
C. The LLDP reinitialisation delay is 5 seconds.
D. The LLDP interface state is Enabled.
E. The LLDP timer is 60 seconds.
Answer: BD
QUESTION 407
Which two statements about GLBP are true? (Choose Two)
A. The AVF responds to ARP request for the virtual IP address.
B. LAN client traffic is handled by the active AVF only.
C. The AVG assigns virtual MAC addresses to GLBP group members.
D. The AVF assigns virtual MAC addresses to GLBP group members.
E. The AVG responds to ARP requests for the Virtual IP address.
Answer: CE
QUESTION 408
Which option is a CISCO recommended RSPAN configuration practice?
A. Define RSPAN VLAN before configuring an RSPAN source and destination session.
B. Assign access ports to an RSPAN VLAN like any other campus VLAN.
C. Use a different RSPAN VLAN for each session if configuring RSPAN on multiple switches.
D. Use only one destination port for EACH RSPAN Session.
Answer: A
QUESTION 409
……
I have uploaded all the real questions of 300-115 exam to my Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDM0pqaFJWUXVuM2M
Welcome to download them freely!