SIMULATION
You have been tasked with configuring multilayer SwitchC, which has a partial configuration
and has been attached to RouterC as shown in the topology diagram.
You need to configure SwitchC so that Hosts H1 arid H2 can successful ping the server S1.
Also SwitchC needs to be able to ping server SI.
Due to administrative restrictions and requirements you should not add/delete vlans or
create trunk links Company policies forbid the use of static or default routing All routes must
be learned via EIGRP 65010 routing protocol.
You do not have access to RouteC, RouterC is correctly configured. No trunking has been
configured on RouterC.
Routed interfaces should use the lowest host on a subnet when possible. The following
subnets are available to implement this solution:
• 172.16.1.0/24
• 192.168.3.32/27
• 192.168.3.64/27
Hosts H1 and H2 are configured with the correct IP address and default gateway.
SwitchC uses Cisco as the enable password.
Routing must only be enabled for the specific subnets shown in the diagram.
Note: Due to administrative restrictions and requirements you should not add or delete
VLANs, changes VLAN port assignments or create trunks. Company policies forbid the use
of static or default routing. All routes must be learning via the EIGRP routing protocol.
HOST 1
HOST 2
Answer: See the explanation.
Explanation:
Here are Step by Step Configuration:On switch C:
ip routing
router eigrp 65010
network 172.16.1.0 0.0.0.255
network 192.168.3.32 0.0.0.31
network 192.168.3.64 0.0.0.31
no auto-summ