how can ARP traffic be controlled?

When a Cisco ASA is configured in transparent mode, how can ARP traffic be controlled?

When a Cisco ASA is configured in transparent mode, how can ARP traffic be controlled?

A.
By enabling ARP inspection; however, it cannot be controlled by an ACL

B.
By enabling ARP inspection or by configuring ACLs

C.
By configuring ACLs; however, ARP inspection is not supported

D.
By configuring NAT and ARP inspection

Show Hint

Leave a Reply 4

Your email address will not be published. Required fields are marked *

Sidza

Sidza

Even though the transparent mode acts as a bridge, Layer 3 traffic, such as IP traffic, cannot pass through the security appliance unless you explicitly permit it with an extended access list. The only traffic allowed through the transparent firewall without an access list is ARP traffic. ARP traffic can be controlled by ARP inspection.

Reply

Mario

Mario

New 300-206 Exam Questions and Answers Updated Recently (28/Sep/2017):

NEW QUESTION 257
A network engineer must mange and configurations to a cisco networking environment solutions accomplishes this task?

A. Cisco IPS manage express and pushing configuration to the IPS units.
B. Cisco security 4.5 or later and pushing configuration bundles to each of the IPS units.
C. Cisco adaptive security device manager to push configuration to each of the IPS.
D. Fire SIGHT manager to bundle and push configuration to the IPS units installed.

Answer: D

NEW QUESTION 258
Which two option are main challenges for public cloud data center?

A. deployment cost
B. tenant isolation
C. disaster recovery
D. system scalability
E. network visibility

Answer: BE

NEW QUESTION 259
A network engineer must manage and push configurations to a Cisco networking environment, in which 10 Cisco ASA with IPS modules reside. Which solution accomplishes this task?

A. Cisco Adaptive Security Device Manager to push configurations to each of the IPS units.
B. FireSIGHT manager to bundle and push configurations to the IPS units installed on an SSD within the Cisco ASA 5500 Series ASA.
C. Cisco Security Manager 4.5 or later and pushing configuration bundles to each of the IPS units.
D. Cisco IPS Manager Express and pushing configurations to the IPS units.

Answer: B

NEW QUESTION 260
When configuring packet-tracer command from CLI, what is the first option that you set?

A. source IP address
B. destination IP address
C. interface
D. protocol (ip, tcp, udp)

Answer: C

NEW QUESTION 261
What is a benefit the iOS control plane protection?

A. It allows QOS policing of aggregate control-panel
B. It provides for early dropping of packets directed toward closed
C. It prevents the input guide from being overwhelmed by any single
D. It minimizes the number of unprocessed packets a protocol can have

Answer: B

NEW QUESTION 262
Which two voice and video protocols does the Cisco ASA 5500 Series support with Cisco Unified Communications Application Inspection? (Chose two.)

A. SCTP
B. SDP
C. H.323
D. H248
E. SCCP
F. SRTP

Answer: CE

NEW QUESTION 263
Which two option are protocol and tools are used by management plane when using cisco ASA general management plane hardening?

A. Unicast Reverse Path Forwarding
B. NetFlow
C. Routing Protocol Authentication
D. Threat detection
E. Syslog
F. ICMP unreachables
G. Cisco URL Filtering

Answer: BE

NEW QUESTION 264
……

P.S. These New 300-206 Exam Questions Were Just Updated From The Real 300-206 Exam, You Can Get The Newest 300-206 Dumps In PDF And VCE From — https://www.passleader.com/300-206.html (270q VCE and PDF)

Good Luck!

Reply