Which will ensure that ARP inspection works as expected?

A switch is being configured at a new location that uses statically assigned IP addresses. Which
will ensure that ARP inspection works as expected?

A switch is being configured at a new location that uses statically assigned IP addresses. Which
will ensure that ARP inspection works as expected?

A.
Configure the ‘no-dhcp’ keyword at the end of the ip arp inspection command

B.
Enable static arp inspection using the command ‘ip arp inspection static vlan vlan-number

C.
Configure an arp access-list and apply it to the ip arp inspection command

D.
Enable port security



Leave a Reply 1

Your email address will not be published. Required fields are marked *


André De

André De

New 300-206 Exam Questions and Answers Updated Recently (6/Feb/2016):

NEW QUESTION 197
How much storage is allotted to maintain system,configuration , and image files on the Cisco ASA 1000V during OVF template file deployment?

A. 1GB
B. 5GB
C. 2GB
D. 10GB

Answer: C

NEW QUESTION 198
Which feature is a limitation of a Cisco ASA 5555-X running 8.4.5 version with multiple contexts?

A. Deep packet inspection
B. Packet tracer
C. IPsec
D. Manual/auto NAT
E. Multipolicy packet capture

Answer: C

NEW QUESTION 199
When access rule properties are configured within ASDM, which traffic direction type is required by global and management access rule?

A. Any
B. Both in and out
C. In
D. Out

Answer: C

NEW QUESTION 200
Which option is a different type of secondary VLAN?

A. Transparent
B. Promiscuous
C. Virtual
D. Community

Answer: B

NEW QUESTION 201
Refer to the exhibit. Which statement about this access list is true?

access-list test: extended premit ip 2001:DB5:7::/64
192.168.1.0 255.255.255.0

A. This access list does not work without 6to4 NAT
B. IPv6 to IPv4 traffic permitted on the Cisco ASA by default
C. This access list is valid and works without additional configuration
D. This access list is not valid and does not work at all
E. We can pass only IPv6 to IPv6 and IPv4 to IPv4 traffic

Answer: D

NEW QUESTION 202
Which option must be configured on a transparent Cisco ASA adaptive security appliance for it to be managed over Layer 3 networks?

A. Static routes
B. Routed interface
C. Security context
D. BVI

Answer: D

NEW QUESTION 203
Which statement about Dynamic ARP Inspection is true ?

A. In a typical network, you make all ports as trusted expect for the ports connection to switches , which are untrusted
B. DAI associates a trust state with each switch
C. DAI determines the validity of an ARP packet based on valid IP to MAC address binding from the DHCP snooping database
D. DAI intercepts all ARP requests and responses on trusted ports only
E. DAI cannot drop invalid ARP packets

Answer: C

NEW QUESTION 204
Which command is the first that you enter to check whether or not ASDM is installed on the ASA?

A. Show ip
B. Show running-config asdm
C. Show running-config boot
D. Show version
E. Show route

Answer: B

NEW QUESTION 205
Which option is the Cisco ASA on-box graphical management solution?

A. SSH
B. ASDM
C. Console
D. CSM

Answer: B

NEW QUESTION 206
……

P.S. These New 300-206 Exam Questions Were Just Updated From The Real 300-206 Exam, You Can Get The Newest 300-206 Dumps In PDF And VCE From — http://bitly.com/1Pg5mjR (222q)

Good Luck !!!