which Cisco Catalyst switch CLI command is used to conf…

When setting up a Cisco IPS appliance in promiscuous mode, which Cisco Catalyst switch CLI command is used to configure SPAN on the switch?

When setting up a Cisco IPS appliance in promiscuous mode, which Cisco Catalyst switch CLI command is used to configure SPAN on the switch?

A.
span source in interface configuration mode

B.
span session in global configuration mode

C.
monitor destination in interface configuration mode

D.
monitor session in global configuration mode

E.
mirror session in global configuration mode

Explanation:
http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015c61 2.shtml



Leave a Reply 0

Your email address will not be published. Required fields are marked *