Which three of these correctly describe how you can perform this configuration?

You are using IPv6, and would like to configure EIGRPv3. Which three of these correctly describe how you can perform this configuration? (Choose three.)

A.
EIGRP for IPv6 is directly configured on the interfaces over which it runs.

B.
EIGRP for IPv6 is not configured on the interfaces over which it runs, but if a user uses passive-interface configuration, EIGRP for IPv6 needs to be configured on the interface that is made passive.

C.
There is a network statement configuration in EIGRP for IPv6, the same as for IPv4.

D.
There is no network statement configuration in EIGRP for IPv6.

E.
When a user uses a passive-interface configuration, EIGRP for IPv6 does not need to be configured on the interface that is made passive.

F.
When a user uses a non-passive-interface configuration, EIGRP for IPv6 does not need to be configured on the interface that is made passive

Explanation:
Below is some information EIGRPv6:

IPv6 EIGRP and IPV4 EIGRP are very similar in concept except for the following differences:

* IPv6 is configured on interface basis (like OSPFv3 and RIPng) and networks are advertised based on interface command -> C is correct.
* When configured on interface, IPv6 EIGRP is initially placed in shutdown state
* As with OSPFv3, IPv6 EIGRP require a router-id in IPv4 format
* Passive interfaces can only be configured in the routing process mode
* Need for extra memory resources and supported in IOS 12.4(6)T and later
* No split horizon in IPv6 because it is possible to get multiple prefixes per interface
* No concept of classful routing in IPv6 EIGRP consequently no automatic summary -> B is not correct

EIGRPv6 uses the router configuration command distribute-list prefix-list to perform route filtering, and when configuring route filtering the route-map command is not supported -> E is correct but D is not.

Virtual Routing and Forwarding (VRF) is also supported in EIGRPv6.