Refer to the exhibit. You are asked to enable redirection for a network optimization engine that will be connected directly to your company CPE. What is the correct configuration to enable redirection for traffic optimization?
A.
(config)#interface s0/0 (config-if)#ip wccp 61 out (config)#interface e0/0 (config-if)#ip wccp 62 out
B.
(config)#interface s0/0 (config-if)#ip wccp 62 in (config)#interface e0/0 (config-if)#ip wccp 61 in
C.
(config)#interface s0/0 (config-if)#ip wccp 61 in (config-if)#ip wccp 62 out
D.
(config)#interface e0/0 (config-if)#ip wccp 61 in (config-if)#ip wccp 62 out
E.
(config)#interface e0/0 (config-if)#ip wccp 61 out (config-if)#ip wccp 62 in
F.
(config)#interface s0/0 (config-if)#ip wccp 61 out (config-if)#ip wccp 62 in
Explanation:
Configuring WCCP for redirection for inbound traffic on interfaces allows you to avoid the overhead associated with CEF forwarding for outbound traffic. Setting an output feature on any interface results in the slower switching path of the feature being taken by all packets arriving at all interfaces. Setting an input feature on an interface results in only those packets arriving at that interface taking the configured feature path; packets arriving at other interfaces will use the faster default path. Configuring WCCP for inbound traffic also allows packets to be classified before the routing table lookup, which translates into faster redirection of packets.The following example shows a configuration session in which redirection of HTTP traffic arriving on interface 0/1 is enabled:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# interface ethernet 0/1
Router(config-if)# ip wccp web-cache redirect in
Router(config-if)# ^Z
Router# show ip interface ethernet 0/1
. . .
WCCP Redirect inbound is enabled
WCCP Redirect exclude is disabled