What does this log message indicate?
4w6d: %PM-4-ERR_DISABLE: Psecure-Violation Error Detected on Gi3/2, Putting Gi3/2 in Err-Disable State
A.
The port has been disabled because the traffic rate limit has been exceeded
B.
The port has been temporarily disabled because the broadcast packet limit has been exceeded
C.
The port has been disabled because the MAC address limit has been exceeded
D.
The port has been disabled due to a DHCP OFFER packet
E.
The port has been disabled due to detection of a gratuitous ARP packed
F.
The port has been disabled due to an invalid MAC address
C. The port has been disabled because the MAC address limit has been exceeded.
C, port-security isn’t to stop invalid MAC addresses. The CAM table will do that. It is to limit the number of MAC addresses allowed.