Refer to the exhibit.
You want to use 3500e APs to setup an indoor mesh deployment. After you change the AP mode,
the AP will not rejoin the Cisco WLC. Which debug command was run, according to the exhibit, and
why is the AP not rejoining the Cisco WLC?
A.
debug capwap packet was run, and 3500e APs do not support indoor mesh.
B.
debug pm pki was run, and you must disable VLAN transparent for 3500e indoor mesh
deployments.
C.
debug mesh security was run, and the 3500e radio MAC address is not in the local MAC filter list
on the Cisco WLC
D.
debug ap join was run, and you must disable VLAN transparent for 3500e indoor mesh
deployments.
E.
debug capwap events enable was run, and the 3500e Ethernet MAC address is not in the local
MAC filter list on the Cisco WLC