DRAG DROP
A small local business recently had an outage after an employee plugged a switch into the
corporatenetwork, which caused the trafficpatternin the network to change. Youhave been
tasked to redesign the network so that this does not happen again. From the left side to the
right side, drag the PVRST+ features that should be implemented to prevent the corresponding
root cause. Not all sources will be used.
Answer: 
Explanation:
<map><m x1=”18″ x2=”369″ y1=”25″ y2=”63″ ss=”0″ a=”0″ /><m x1=”19″ x2=”371″
y1=”84″ y2=”125″ ss=”0″ a=”0″ /><m x1=”18″ x2=”368″ y1=”145″ y2=”186″ ss=”0″ a=”0″ /><m
x1=”18″ x2=”369″ y1=”205″ y2=”246″ ss=”0″ a=”0″ /><m x1=”20″ x2=”367″ y1=”263″ y2=”305″
ss=”0″ a=”0″ /><m x1=”21″ x2=”369″ y1=”324″ y2=”365″ ss=”0″ a=”0″ /><m x1=”399″ x2=”747″
y1=”44″ y2=”86″ ss=”1″ a=”0″ /><m x1=”397″ x2=”746″ y1=”96″ y2=”136″ ss=”1″ a=”0″ /><m
x1=”397″ x2=”747″ y1=”147″ y2=”185″ ss=”1″ a=”0″ /><m x1=”399″ x2=”748″ y1=”245″
y2=”286″ ss=”1″ a=”0″ /><c start=”0″ stop=”0″ /><c start=”3″ stop=”1″ /><c start=”5″ stop=”2″
/><c start=”2″ stop=”3″ /></map>
21st/Dec/2017 New Cisco 352-001 Exam Questions:
QUESTION
As a service provider you must support a Layer 2 virtualization protocol that does not include the use of label switching. Which option can meet this design requirement?
A. VPLS
B. VRF-Lite
C. QinQ
D. 802.3ad
Answer: C
QUESTION
Which two techniques are used in a network design to slow down the distribution of topology information caused by a rapidly flapping link? (Choose two.)
A. Bidirectional Forwarding Detection
B. IP event dampening
C. link-state incremental SPF
D. link-state partial SPF
E. LSA throttling
F. SPF throttling
Answer: BE
QUESTION
When designing a WAN that will be carrying real-time traffic, what are two important reasons to
consider serialization delay? (Choose two.)
A. Serialization delays are variable because they depend on the line rate of the interface and on the type
of the packet being serialized.
B. Serialization delay depends not only on the line rate of the interface but also on the size of the packet.
C. Serialization delays are invariable because they depend only on the line rate of the interface.
D. Serialization delays are variable because they depend only on the size of the packet being serialized.
E. Serialization delay is the time required to transmit the packet on the physical media.
Answer: BE
QUESTION
In a redesign of a multiple-area network, it is recommended that summarization is to be implemented. For redundancy requirements, summarization is done at multiple locations for each summary. Some customers now complain of higher latency and performance issues for a server hosted in the summarized area.
What design issues should be considered when creating the summarization?
A. Summarization adds CPU overhead on the routers sourcing the summarized advertisement.
B. Summarization prevents the visibility of the metric to the component subnets.
C. Summarization creates routing loops.
D. Summarization causes packet loss when RPF is enabled.
Answer: B
QUESTION
Refer to the exhibit. What limitations exist in this design, given that the access layer devices are expected to steadily increase by two devices per week for the next year?
A. scalability
B. serviceability
C. redundancy
D. resiliency
Answer: A
QUESTION
What is a key design aspect to be considered when designing an IP network that will be carrying real-time VoIP traffic?
A. Minimizing total bidirectional end-to-end delay to 0-150 ms
B. Minimizing total unidirectional end-to-end delay to 150-500 ms
C. Minimizing total bidirectional end-to-end delay to 0-50 ms
D. Minimizing total unidirectional end-to-end delay to 0-150 ms
Answer: D
More new 352-001 Exam Questions: https://www.braindump2go.com/352-001.html