Refer to the exhibit.
Which OSPFv3 routes will be visible in the routing table of R2?
A.
2001:12::1/128
B.
2001:12::1/128, 2001:112::1/128
C.
2001:12::2/128
D.
No OSPFv3 routes will be visible.
Which OSPFv3 routes will be visible in the routing table of R2?
Refer to the exhibit.
Which OSPFv3 routes will be visible in the routing table of R2?
The command “ipv6 unicast-routing” needs to be configured on both routers before any IPv6 routes will be seen.
the commands shown would not be accepted without “ipv6 unicast-forwarding” having been already applied
D is right because you should add “include-connected” when redistributing from RIPNG to OSPFv3 to redistribute that loopback.