What needs to be done to enable these hosts to ping each another?

Refer to the topology and partial switch command output shown in the graphic. The internetwork
shown in the diagram is experiencing connectivity problems. Host A is unable to ping Host B.
What needs to be done to enable these hosts to ping each another?

Refer to the topology and partial switch command output shown in the graphic. The internetwork
shown in the diagram is experiencing connectivity problems. Host A is unable to ping Host B.
What needs to be done to enable these hosts to ping each another?

A.
The Fa0/1 interface on the ET-1 switch must be configured as a trunk port.

B.
Switch port Fa0/1 must be moved to a different VLAN.

C.
VLAN 2 must be named.

D.
The gateway on Host A needs to be changed.

E.
The IP address on Host B needs to be reconfigured.

Explanation:
Interface FA0/1 should be in any case configured as a trunk port so that a router could switch
packets between the VLANs. The IP addresses are acceptable, so no issues should be caused
due this.



Leave a Reply 0

Your email address will not be published. Required fields are marked *